error, final result code +CMS ERROR: <err> is returned. See chapter Message Service Failure Result Code for a list of <err> values. This command should be abortable.
-entered text (3GPP TS 23.040
-the TA shall send a four character sequence <CR><LF><greater_than><space> (IRA 13, 10, 62, 32) after command line is terminated with <CR>; after that text can be entered from TE to ME/TA.
-the DCD signal shall be in ON state while text is entered.
-the echoing of entered characters back from the TA is controlled by V.25ter echo command E.
-the entered text should be formatted as follows:
-if <dcs> (set with +CSMP) indicates that 3GPP TS 23.038 GSM 7 bit default alphabet is used and <fo> indicates that 3GPP TS 23.040
-if TE character set other than "HEX" (refer command Select TE Character Set +CSCS in 3GPP TS 27.007 ): ME/TA converts the entered text into the GSM 7 bit default alphabet according to rules of Annex A; backspace can be used to delete last character and carriage returns can be used (previously mentioned four character sequence shall be sent to the TE after every carriage return entered by the user);
-if TE character set is "HEX": the entered text should consist of two IRA character long hexadecimal numbers which ME/TA converts into the GSM 7 bit default alphabet characters. (e.g. 17 (IRA 49 and 55) will be converted to character Π (GSM 7 bit default alphabet 23)).
-if <dcs> indicates that
-sending can be cancelled by giving <ESC> character (IRA 27).
-
Table 12. +CMGS action command syntax
Command | Possible response(s) |
if text mode (+CMGF=1): | if text mode (+CMGF=1) and sending |
+CMGS=<da> [,<callback_num>] | successful: |
[,<toda>] | +CMGS: <mr>[,<scts>] |
<CR> | if sending fails: |
text is | +CMS ERROR: <err> |
| |
| <Cmotech > |
| AT+CMGS="dest_addr"[,"callback_addr"] |
| [,<toda>] |
+CMGS=? |
|
8.1.1.16.3G Send Message from Storage +CMSS
Execution command sends message with location value <index> from preferred message storage <mem2> to the network
Extended AT Commands Manual | Page 41 of 70 |