1 2 . TIA/EIA/IS - 707A AT COMMAND SET
12.1.1. User modified profiles & NVM changes
12.1.1.1.User Profile store (AT&Wn)
This command is used for saving the current operating profile as a User Profile.
Table 12.75 Set command
Command | TE2 | Æ | MT2 | &W<value> |
|
Response | TE2 | Å | MT2 | (OK ERROR) | |
Value | 1~5 User Profiles slots available. | 0 is Factory Default and is unavailable | |||
|
|
|
|
|
|
12.1.1.2.User Profile recall (AT&Fn)
This command is used for confirming or recalling the User Profile. At each power up of modem or &Fn command the profile set by &Fn is loaded into the working area of Memory.
If user has not saved a profile to &Fn an attempt to load that profile using &Fn will elicit an ERROR response.
&F0 cannot be written to, using &W0 command. An attempt to write to that profile using &W0 will elicit an ERROR response.
Table 12.76 Read command
Command | TE2 | Æ | MT2 | &F? |
Response | TE2 | Å | MT2 | &F: <value> |
Value | 0~5 (0: Factory Default Profile) | |||
Table 12.77 Set command |
| |||
Command | TE2 | Æ | MT2 | &F<value> |
Response | TE2 | Å | MT2 | (OK ERROR) |
|
|
|
|
|
Extended AT Commands Manual | Page 55 of 70 |