Maxon Telecom MM-6280IND manual 13.1.1. RM3 AT$$NOTIDS, TE2 MT2 $$NOTIDS?

1 3 . Multiplexing

13.1.1.RM3 (AT$$NOTI_DS)

Command to activate the RM3 feature of the modem, which will open a UDP channel of communication with the modem and can be used to send direct AT commands to the modem,

during packet data session. In Idle state modem will not use UDP for notification. Communication between MT2 and PC will be as follow

From MT2 to PC IP Address 0.0.0.1 and port 33333 From PC to MT2 IP Address 1.1.1.1 and port 33333

Table 13-83 Read command

Command	TE2	Æ	MT2	$$NOTI_DS?
Response	TE2	Å	MT2	$$NOTI_DS: <value>
Value	0: Not Active, 1: Active
Table 13-84 Set command
Command	TE2	Æ	MT2	$$NOTI_DS
Response	TE2	Å	MT2	$$NOTI_DS=<value>

Extended AT Commands Manual Page 65 of 70 2009-06-25