GBC 930-028 manual Tools required, To uncrate the laminator

Installation		F-60+ Operation and Maintenance Manual
8QSDFNLQJ
		2. There are two hold down bridges that are con-
☞ NOTE		nected to sides 4 and 5. Remove the hold down
		bridges and then remove sides 4 and 5.
ALL SHIPMENTS ARE EX- WORKS. At our dock title
passes to the buyer. Please review your insurance cov-
erage prior to shipment, as you are responsible for all				CAUTION
subsequent freight charges and risks. Before signing
the Bill of Lading you should be sure to inspect the		Do not allow the top to fall into the crate. It can
crate and/or pallet for signs of damage or missing
		damage the laminator.
items; if applicable, make a note of this on the Bill of
		Do not put packing screws on the floor. They can
Lading.
The F-60+ Laminator is shipped in a wood crate on a		cause problems when trying to roll the machine
			into position.
skid.
		A second person must support the side
		labeled (5) in Figure 2-3. It can fall and damage
	WARNING		the laminator.

The unpacking process requires at least two people. You can be severely injured or crushed.

3.The ramps are attached to the skid. Remove them and set them aside for later installation.

Tools required:

•Phillips head screwdriver

•Adjustable wrench

To uncrate the laminator:

1.Remove the top of the crate and sides 2 and 3 as shown in Figure 2-3.

3 1 5

Install

Screws

4

F- 60 +™

	H
PR	O-TEC
	2

Figure 2-3: Removing the Crate

Saddle	2" x 4"	Heaters
		2" x 4"
		Saddle
Skid		Skid
		Lag Bolt

2" x 4"

Skid

Lag Bolt

Saddle

Figure 2-4: Skid Configuration

CAUTION

Do not use a knife or other sharp instrument

during installation or while servicing the

laminator. You can cause irreparable damage to

the rolls.

2-4 © GBC Pro-Tech 1999 April