3URFHGXUH3DVV |
|
Operation |
1.Prepare to put the print through a second time to mount the print to the substrate - anything from wood, to Masinote, to Gator foam. Start by setting the shims to the appropriate spacing for the mate- rial used.
2.Trim the board to the size of the print.
3.Align the work to the board and ensure an exact fit. Place weights on the center of the print to make sure that it does not move relative to the board dur- ing the next steps.
4.Raise one end of the print and peel back approxi- mately two inches of the liner to expose the adhe- sive that was applied to the print in the first pass. Fold it under.
5.Lay the print back down evenly and extremely flat. From the center outward, tack the exposed adhe- sive to the substrate.
6.Position the piece so that the end with the liner peeled back is facing the nip. Insert the first one inch of the board into the nip. Very carefully wrap the print back and over the top laminating roll. Be sure there are no wrinkles in the nip area. Carefully peel off the liner as the board progresses through the laminator.
7.Trim the piece to the finished size.
© GBC |