/HYHOLQJ | 6WDUWXS | Installation |
|
|
Tools required:
•Adjustable wrench
•Carpenter's level
To level the laminator:
1.Raise each end, remove the castors and install a leveling pad and stud onto each of the foot brackets at the four bottom corners of the laminator. Thread third nut on stud below cabinet.
2.Thread stud into 4 leveling pads and lock down with nut. Thread second nut onto stud.
3.Place a carpenter's level front to rear across the two lower tie bars at one end of the machine.
4.Level this end of the machine front to rear, raising or lowering the leveling pads by adjusting the mid- dle nuts on the foot bolts.
5.Move the level to the other end of the machine and level front to rear.
6.Place the level directly on one of the tie bars and level the machine side to side.
7.Recheck the front to rear level condition to insure that it has not changed. If it has, repeat the leveling procedure.
8.When all the measurements indicate that the machine is level, tighten down the top nuts on the foot brackets to lock the pads in their current posi- tion.
The first time the laminator is started and every time it is serviced you should use the following checklist to confirm that the unit is operating properly and that all safety mechanisms are functioning.
Startup Checklist
Start the laminator and go through the following check- list.
❏Are the emergency stop buttons working?
Push down on one of the emergency stop buttons. The laminator should stop. Rotate and pull up on the button and push the reset button on the lower back of the laminator. The laminator should resume operation. Always check all buttons.
WARNING
Never operate the laminator unless all of the emergency stop buttons are functioning properly. You can be crushed or burned.
❏Are the guard table switches working?
With the laminator running, pull the front guard towards you. The rolls should stop. Move the guard back in. Press the RUN button on the front control panel. The laminator should resume operation.
WARNING
Never operate the laminator unless the
mechanical guard system is operating properly.
You can be crushed or burned.
❏Is the footswitch working?
Press the footswitch. The laminator should start operation. Vary the speed using the footswitch (like an automobile accelerator) to ensure that the foot- switch is operating properly at various speeds.
© GBC |