Adjustments
Canceling the Moire
Switching the Input Connector
The adjustment data becomes the unique setting for the input signals received.
1 Press the OPTION button.
The OPTION OSD (On Screen Display) appears.
| COLOR TEMPERATURE | |
| CANCEL MOIRE | |
| INPUT: | HD1 5 BNC |
OPTION | LOCK: | UNLOCK LOCK |
| ||
| 80.0KHz/ 75Hz | |
| SELECT | SET |
2 Press the ¨ ./> buttons to select “CANCEL MOIRE” and then press the > / button.
CANCEL MOIRE
OFF ON
31
SET 
3 Press the > ?// buttons to select “ON” and then press the ¨ . button.
CANCEL MOIRE
OFF ON
31
SELECT 
SET 
4 Press the > ?// buttons to adjust for minimum moire.
To erase the “CANCEL MOIRE” OSD, press the OPTION button again.
The OSD automatically disappears 30 seconds after you release the buttons.
To reset, press the RESET button while the OSD is on.
Note
When the moire is cancelled, the picture may be fuzzy. Adjust the moire gradually from 0, and stop the adjustment as near to 0 as possible.
As the monitor has two sets of input connectors, you can switch between two input video signals. It is necessary to select the connector type (HD15/5 BNC's) correctly according to the connection.
1 Press the OPTION button.
The OPTION OSD (On Screen Display) appears.
| COLOR TEMPERATURE | |
| INPUT: | HD1 5 BNC |
| LOCK: | UNLOCK LOCK |
OPTION | 80.0KHz/ 75Hz | |
| ||
| SELECT | SET |
2 Press the ¨ ./> buttons to select “INPUT” and then press the > ?// button to select “HD15” or “BNC.”
/
When you switch between input sources, the monitor screen is muted for a moment (Mute) then the signal through the selected input is displayed. If the selected input do not receive any video signals, the monitor automatically returns to the other input after Mute and the OPTION OSD appears.
To erase the OPTION OSD, press the OPTION button again. The OSD automatically disappears 30 seconds after you release the buttons.
If two computers are connected to the monitor (one to each input), when one of the computers is turned on or restarted, or the monitor goes into power saving mode, the monitor may switch to the other input because the signal is temporarily interrupted. Select the input which you use, following the above steps.
10