Pitney Bowes DA950 manual Basics, Setting Up a Job, Set the Separator Gap

Basics

Setting Up A Job

Setting up a print job means adjusting the printer to ac- commodate the width, height, thickness and weight of your material.

There are two things that determine how reliably your printer feeds: the setup adjustments and the quality of your material. A good setup minimizes misfeeds and jams. And your printer will perform at its best when you run material that falls within our published specifications. See Appendix B for complete material specifications.

1. Set the Separator Gap

Whenever you switch from one material type to another, you need to set the gap between the separators and the feed roller before printing begins.

There are three positions of the "H" Block:

•Lever fully down - adjusted to media thickness (ready to operate).

•Lever midpoint - not adjusted to any media (free-floating on media, not set up to operate).

•Lever fully up - locked in the up position, not adjusted to any media thickness.

2