Basics
Setting Up A Job (continued)
3. Set the Feed Angle
The feed angle of the feed ramp depends on the type of material you're running:
•Heavy material: adjust to a low angle
•Standard material: adjust to the center (45 degree angle)
•Light material: adjust to a high angle
To make the adjustment:
A. Make sure the wire form adjustment slide is loosened.
B. Move the feed ramp up or down as required.
C. Tighten the adjustment slide to secure the ramp.
4. Set the Feed Ramp Length
Extend the feed ramp if you are running a longer piece of material.
A. Loosen the feeder locking knob.
B. Pull the feeder extension out.
C. Tighten the feeder locking knob to secure.
5