Introduction
4.Selection Buttons and Indicator Lights
Press these buttons to step through the feeders and options that are available on your machine.
Depending on your model configuration, some indicator lights and associated feeders may be inoperable. If your model doesn’t have a second sheet feeder, for example, the indicators associated with this feeder will not light. This is normal.
A green indicator shows that a feeder or function is selected for use.
A red indicator shows that you selected an invalid (impossible) combination of functions. Simply correct the error in selection and the indicator(s) will change back to green.
An unlit indicator means that the feeder or function is turned OFF.
5.Trial Piece
After you’ve set up a job using the control panel, you must run a trial piece. If you press Start before running a trial piece, the machine display will prompt you to run a trial piece first.
Press this button to run one fully collated piece as programmed via the control panel. The envelope will not seal regardless of whether the system has been told to seal or not. This allows you to inspect the processed job to make sure that everything is inserted correctly and that the address appears in the window.
The trial piece also allows the system to calibrate itself and set its double detect feature, if selected.
IMPORTANT: Running the trial piece is an essential function for the machine to perform. You must do it before a start every time you use a new batch of material. This allows the system to
6.Start
Press to begin automatic operation.
7.Stop
Press to stop automatic operation at the end of the next cycle.
About the Sleep Mode
After 10 minutes of inactivity, the system enters a
“sleep mode” and displays Powersave On. Pressing any button will wake the machine up. The machine remembers the last job setup.
OfficeRight™ DI200 Operator’s Guide | 7 |