Intermec 6642 manual Power LED, Battery LED, Speaker

Page 15

Overview

SECTION 1

Power LED

When this LED is green, the pen computer is operating.

When this LED is red, the pen computer is in the suspend, to,RAM state.

If this LED is off, the pen computer is either not operating or is in the suspend,to,disk state.

HDD LED

When the bottom green LED is flashing, the pen computer is accessing the hard drive.

Battery LED

When this LED is green, it indicates that power is being supplied by the AC adapter. In addition, if the expansion battery is installed on the pen computer, that battery pack is being charged too.

When this LED is off, it indicates that the pen computer is running off battery power.

When this LED is red, it indicates that the battery voltage has dropped and that there is little battery capacity remaining.

Speaker

The speaker outputs audio from the Windows sound system compatible chipset. When the audio input/output jack is used for headphones or line output, the internal speaker is disconnected.

1-6PEN*KEYR 6642 Pen Computer User’s Guide

Image 15

Contents Pen Computer Acknowledgments FCC Computer Compliance Telephone Installation Warning Notices Only with the same or equivalent type Contents Software Included with the 6642 Pen Computer Before connecting peripherals Figures Introduction About this Manual SectionPEN*KEYR 6642 Pen Computer OverviewOverview Front View Power Button Power LED Battery LEDSpeaker Pen Removal Pen StylusSide Views Infrared Communications Port Rear ViewBottom View Reset Switch Internal Battery Pack Charging Using the Pen Computer for the First Time Connecting the AC Adapter Startup System StartupInputting Text Pen Stylus InputSelecting an Item pointing Moving Items/Resizing WindowsPen Operation Connect Devices Using the External Floppy Drive/Port Expander Removing External Floppy Disk Drive/Port Expander Inserting and Removing Floppy Disks Handling Floppy DisksFormatting a Floppy Disk General Information WindowsSoftware Included with Pen Computer Windows 98 Help Help With Operating ProceduresKeyword ContentsHelp Regarding Items on Screen PEN*KEY Utility Tool 6PEN*KEYR 6642 Pen Computer User’s Guide Section Suspend SetupKeypad Assign Pen Calibration Pen Calibration Exiting the PEN*KEY Tool Checking the Version of the PEN*KEY ToolCIC Handwriting Recognition On Screen Keyboard Right Mouse Button SettingBattery Charge Battery UseCharging Internal Battery Pack Attaching the Expansion Battery Pack Attaching the Expansion Battery Drop the Battery into Tabs, Slide it to the Right Confirming the Remaining Battery Pack Capacity Remaining Battery Pack Capacity DisplaySection Low Battery Warning Charging and Operating Times Pen computer is usingBattery Disposal Before connecting peripherals Connecting Peripheral EquipmentPeripheral Equipment Connectors Floppy Drive/Port ExpanderAudio I/O Keyboard/Mouse USB ConnectionSvga Port Switching the DisplayInstalling a Printer Driver PrinterRS-232C Settings for Infrared Communication IrDA CommunicationsPreparing the 6642 and the Target Device Logical Port Disabling IR CommunicationCommunication with a PC PC Card Slot Removing a PC Card Modem Connecting the Modem Setting Communications InformationSetting Communications Software Troubleshooting Problems on Start-up Problems with Display Problems with Floppy Disk Problems with Hard DiskProblems with Peripherals Problems with Touch Panel6PEN*KEYR 6642 Pen Computer User’s Guide Problems with Communications Other Problems Customer Response Center Factory ServiceWeb Site Bulletin Board Service