Intermec 6642 manual Connectors, Floppy Drive/Port Expander, Audio I/O

Page 58

SECTION 5

Connecting Peripheral Equipment

Connectors

DC Power In

Audio I/O	USB Connector

Floppy Drive/Port Expander

Figure 52

Side View Connections

Floppy Drive/Port Expander

1.Open the floppy drive/port expander cover on the right side of the pen computer.

2.Connect the cable from the floppy drive/port expander* to the 6642 port expander connector.

3.Connect the desired peripheral device (PS/2, parallel or serial peripheral) to the floppy drive/port expander.

4.Apply power to the peripheral, if applicable, then the 6642.

Audio I/O

An internal mini speaker provides audio output from the integrated PCI audio controller on board the 6642. A 2.5mm bayonet socket connector allows for external micro* phone input, and headphone outputs.

PEN*KEYR 6642 Pen Computer User’s Guide 5-3

Image 58

Contents Pen Computer Acknowledgments FCC Computer Compliance Telephone Installation Warning Notices Only with the same or equivalent type Contents Software Included with the 6642 Pen Computer Before connecting peripherals Figures Section Introduction About this ManualOverview PEN*KEYR 6642 Pen ComputerOverview Front View Power Button Battery LED Power LEDSpeaker Pen Stylus Pen RemovalSide Views Rear View Infrared Communications PortBottom View Reset Switch Internal Battery Pack Charging Using the Pen Computer for the First Time Connecting the AC Adapter System Startup StartupMoving Items/Resizing Windows Pen Stylus InputSelecting an Item pointing Inputting TextPen Operation Connect Devices Using the External Floppy Drive/Port Expander Removing External Floppy Disk Drive/Port Expander Handling Floppy Disks Inserting and Removing Floppy DisksFormatting a Floppy Disk Windows General InformationSoftware Included with Pen Computer Help With Operating Procedures Windows 98 HelpContents KeywordHelp Regarding Items on Screen PEN*KEY Utility Tool 6PEN*KEYR 6642 Pen Computer User’s Guide Section Setup SuspendKeypad Assign Pen Calibration Pen Calibration Checking the Version of the PEN*KEY Tool Exiting the PEN*KEY ToolCIC Handwriting Recognition Right Mouse Button Setting On Screen KeyboardBattery Use Battery ChargeCharging Internal Battery Pack Attaching the Expansion Battery Pack Attaching the Expansion Battery Drop the Battery into Tabs, Slide it to the Right Remaining Battery Pack Capacity Display Confirming the Remaining Battery Pack CapacitySection Low Battery Warning Pen computer is using Charging and Operating TimesBattery Disposal Connecting Peripheral Equipment Before connecting peripheralsPeripheral Equipment Floppy Drive/Port Expander ConnectorsAudio I/O USB Connection Keyboard/MouseSwitching the Display Svga PortPrinter Installing a Printer DriverRS-232C IrDA Communications Settings for Infrared CommunicationPreparing the 6642 and the Target Device Disabling IR Communication Logical PortCommunication with a PC PC Card Slot Removing a PC Card Modem Setting Communications Information Connecting the ModemSetting Communications Software Troubleshooting Problems on Start-up Problems with Display Problems with Hard Disk Problems with Floppy DiskProblems with Touch Panel Problems with Peripherals6PEN*KEYR 6642 Pen Computer User’s Guide Problems with Communications Other Problems Factory Service Customer Response CenterWeb Site Bulletin Board Service