Intermec 6642 manual Handling Floppy Disks, Inserting and Removing Floppy Disks

Page 30

SECTION 2

Using the Pen Computer for the First Time

Handling Floppy Disks

"NOTE:Do not open the shutter and touch the disk inside, otherwise you will not be able to read or write data to the disk.

"NOTE:Do not place floppy disks near magnetic or heat sources, or in direct sunlight or dusty environments.

"NOTE:Never subject a disk to to sudden shocks or extreme vibration. Do

not drop, bend, or place heavy objects on a disk.

"NOTE:Do not spill liquids on a disk.

Inserting and Removing Floppy

Disks

Hold the floppy disk with the arrow facing up and towards the drive. Slide the disk until it locks into place.

"NOTE:Make sure the floppy disk is inserted correctly, not upside down. Don’t use excessive force when inserting the disk into the drive. Damage may result to the drive.

Figure 26

Inserting and Removing a Floppy Disk

Press the eject button firmly. The disk will pop out slightly. Remove it and store it properly.

PEN*KEYR 6642 Pen Computer User’s Guide 2-9

Image 30

Contents Pen Computer Acknowledgments FCC Computer Compliance Telephone Installation Warning Notices Only with the same or equivalent type Contents Software Included with the 6642 Pen Computer Before connecting peripherals Figures Section Introduction About this ManualOverview PEN*KEYR 6642 Pen ComputerOverview Front View Power Button Power LED Battery LEDSpeaker Pen Stylus Pen RemovalSide Views Rear View Infrared Communications PortBottom View Reset Switch Internal Battery Pack Charging Using the Pen Computer for the First Time Connecting the AC Adapter System Startup StartupMoving Items/Resizing Windows Pen Stylus InputSelecting an Item pointing Inputting TextPen Operation Connect Devices Using the External Floppy Drive/Port Expander Removing External Floppy Disk Drive/Port Expander Handling Floppy Disks Inserting and Removing Floppy DisksFormatting a Floppy Disk General Information WindowsSoftware Included with Pen Computer Help With Operating Procedures Windows 98 HelpContents KeywordHelp Regarding Items on Screen PEN*KEY Utility Tool 6PEN*KEYR 6642 Pen Computer User’s Guide Section Setup SuspendKeypad Assign Pen Calibration Pen Calibration Checking the Version of the PEN*KEY Tool Exiting the PEN*KEY ToolCIC Handwriting Recognition Right Mouse Button Setting On Screen KeyboardBattery Use Battery ChargeCharging Internal Battery Pack Attaching the Expansion Battery Pack Attaching the Expansion Battery Drop the Battery into Tabs, Slide it to the Right Remaining Battery Pack Capacity Display Confirming the Remaining Battery Pack CapacitySection Low Battery Warning Pen computer is using Charging and Operating TimesBattery Disposal Connecting Peripheral Equipment Before connecting peripheralsPeripheral Equipment Connectors Floppy Drive/Port ExpanderAudio I/O USB Connection Keyboard/MouseSwitching the Display Svga PortInstalling a Printer Driver PrinterRS-232C Settings for Infrared Communication IrDA CommunicationsPreparing the 6642 and the Target Device Logical Port Disabling IR CommunicationCommunication with a PC PC Card Slot Removing a PC Card Modem Connecting the Modem Setting Communications InformationSetting Communications Software Troubleshooting Problems on Start-up Problems with Display Problems with Hard Disk Problems with Floppy DiskProblems with Touch Panel Problems with Peripherals6PEN*KEYR 6642 Pen Computer User’s Guide Problems with Communications Other Problems Factory Service Customer Response CenterWeb Site Bulletin Board Service