Intermec 6642 manual Pen Stylus, Pen Removal

Page 16

SECTION 1

Overview

Pen Stylus

To remove the pen stylus, pull it straight out to the right.

To place the pen back in the pen holder, align the projection on the pen with the groove in the pen holder and then gently slide the pen into the holder. Make sure that you push the pen all of the way in until it locks in place, so that it will not fall out unexpectedly.

Figure 14

Pen Removal

"NOTE:Clean the tip of the pen stylus and wipe the screen with a soft lint– free cloth before use. If you use the pen on the screen while either is dirty, the display could become scratched or the pen might not move smoothly on the display surface.

BCAUTION:	Use only the pen provided or your finger tip. Do not use a wood
	pencil, mechanical pencil, or any other sharp object. Doing so
	will scratch the screen.

PEN*KEYR 6642 Pen Computer User’s Guide 1-7

Image 16

Contents Pen Computer Acknowledgments FCC Computer Compliance Telephone Installation Warning Notices Only with the same or equivalent type Contents Software Included with the 6642 Pen Computer Before connecting peripherals Figures Section Introduction About this ManualOverview PEN*KEYR 6642 Pen ComputerOverview Front View Power Button Battery LED Power LEDSpeaker Pen Stylus Pen RemovalSide Views Rear View Infrared Communications PortBottom View Reset Switch Internal Battery Pack Charging Using the Pen Computer for the First Time Connecting the AC Adapter System Startup StartupPen Stylus Input Selecting an Item pointingMoving Items/Resizing Windows Inputting TextPen Operation Connect Devices Using the External Floppy Drive/Port Expander Removing External Floppy Disk Drive/Port Expander Handling Floppy Disks Inserting and Removing Floppy DisksFormatting a Floppy Disk Windows General InformationSoftware Included with Pen Computer Help With Operating Procedures Windows 98 HelpContents KeywordHelp Regarding Items on Screen PEN*KEY Utility Tool 6PEN*KEYR 6642 Pen Computer User’s Guide Section Setup SuspendKeypad Assign Pen Calibration Pen Calibration Checking the Version of the PEN*KEY Tool Exiting the PEN*KEY ToolCIC Handwriting Recognition Right Mouse Button Setting On Screen KeyboardBattery Use Battery ChargeCharging Internal Battery Pack Attaching the Expansion Battery Pack Attaching the Expansion Battery Drop the Battery into Tabs, Slide it to the Right Remaining Battery Pack Capacity Display Confirming the Remaining Battery Pack CapacitySection Low Battery Warning Pen computer is using Charging and Operating TimesBattery Disposal Connecting Peripheral Equipment Before connecting peripheralsPeripheral Equipment Floppy Drive/Port Expander ConnectorsAudio I/O USB Connection Keyboard/MouseSwitching the Display Svga PortPrinter Installing a Printer DriverRS-232C IrDA Communications Settings for Infrared CommunicationPreparing the 6642 and the Target Device Disabling IR Communication Logical PortCommunication with a PC PC Card Slot Removing a PC Card Modem Setting Communications Information Connecting the ModemSetting Communications Software Troubleshooting Problems on Start-up Problems with Display Problems with Hard Disk Problems with Floppy DiskProblems with Touch Panel Problems with Peripherals6PEN*KEYR 6642 Pen Computer User’s Guide Problems with Communications Other Problems Factory Service Customer Response CenterWeb Site Bulletin Board Service