Intermec 6642 manual Removing External Floppy Disk Drive/Port Expander

Page 29

Using the Pen Computer for the First Time

SECTION 2

BCAUTION:	Do not place the floppy disk drive unit on its side or upside
	down.
BCAUTION:	Do not press on the floppy disk drive unit; it may damage the
	drive or cause malfunction.
BCAUTION:	Do not place the AC adapter on top of the floppy disk drive
	unit; it may cause the drive to malfunction.
	1.	Turn off the computer.
	2.	Open the cover of the external floppy disk drive/port
		expander cover on the right side of the 6642.
	3.	Connect the connector of the floppy disk drive unit to
		the 6642.

Figure 25

Floppy Drive/Port Expander Connector Removal

Removing External Floppy Disk

Drive/Port Expander

1.Remove the floppy disk from the floppy disk drive.

2.Turn off the computer.

3.Disconnect the floppy disk drive unit by simultaneous9 ly pressing the buttons on each side of the connector and pulling them out. See figure 2-5.

4.Close the cover of the floppy disk drive/port expander.

2-8PEN*KEYR 6642 Pen Computer User’s Guide

Image 29

Contents Pen Computer Acknowledgments FCC Computer Compliance Telephone Installation Warning Notices Only with the same or equivalent type Contents Software Included with the 6642 Pen Computer Before connecting peripherals Figures Introduction About this Manual SectionPEN*KEYR 6642 Pen Computer OverviewOverview Front View Power Button Speaker Power LEDBattery LED Pen Removal Pen StylusSide Views Infrared Communications Port Rear ViewBottom View Reset Switch Internal Battery Pack Charging Using the Pen Computer for the First Time Connecting the AC Adapter Startup System StartupSelecting an Item pointing Pen Stylus InputMoving Items/Resizing Windows Inputting TextPen Operation Connect Devices Using the External Floppy Drive/Port Expander Removing External Floppy Disk Drive/Port Expander Inserting and Removing Floppy Disks Handling Floppy DisksFormatting a Floppy Disk Software Included with Pen Computer General InformationWindows Windows 98 Help Help With Operating ProceduresKeyword ContentsHelp Regarding Items on Screen PEN*KEY Utility Tool 6PEN*KEYR 6642 Pen Computer User’s Guide Section Suspend SetupKeypad Assign Pen Calibration Pen Calibration Exiting the PEN*KEY Tool Checking the Version of the PEN*KEY ToolCIC Handwriting Recognition On Screen Keyboard Right Mouse Button SettingBattery Charge Battery UseCharging Internal Battery Pack Attaching the Expansion Battery Pack Attaching the Expansion Battery Drop the Battery into Tabs, Slide it to the Right Confirming the Remaining Battery Pack Capacity Remaining Battery Pack Capacity DisplaySection Low Battery Warning Charging and Operating Times Pen computer is usingBattery Disposal Before connecting peripherals Connecting Peripheral EquipmentPeripheral Equipment Audio I/O ConnectorsFloppy Drive/Port Expander Keyboard/Mouse USB ConnectionSvga Port Switching the DisplayRS-232C Installing a Printer DriverPrinter Preparing the 6642 and the Target Device Settings for Infrared CommunicationIrDA Communications Communication with a PC Logical PortDisabling IR Communication PC Card Slot Removing a PC Card Modem Setting Communications Software Connecting the ModemSetting Communications Information Troubleshooting Problems on Start-up Problems with Display Problems with Floppy Disk Problems with Hard DiskProblems with Peripherals Problems with Touch Panel6PEN*KEYR 6642 Pen Computer User’s Guide Problems with Communications Other Problems Customer Response Center Factory ServiceWeb Site Bulletin Board Service