Intermec 6642 manual USB Connection, Keyboard/Mouse

Page 59

Connecting Peripheral Equipment

SECTION 5

"NOTE:If external stereo speakers are connected to the pen computer, the audio is output from the right channel only.

Adjust the sound volume in the operating system by tapping the speaker icon in the taskbar.

USB Connection

The USB (Universal Serial Bus) is a new generation port for PC97 system hardware design. This 4-pin port allows you to simultaneously connect multiple USB devices through daisy- chaining or through an external hub. The USB specification allows connection of up to 127 USB devices running at up to 12Mbps.

USB connection allows you to disconnect/connect peripherals without turning off the pen computer.

	Keyboard/Mouse
	You can use a keyboard or external mouse with the 6642.
	One keyboard/mouse port is available when the external
	floppy disk drive is connected. A keyboard or mouse can also
	be connected via USB.
BCAUTION:	Do not connect or disconnect devices to the keyboard/mouse
	port while the 6642 is powered on. Doing so will cause improper
	operation.
	Read the manual provided with the device and make the
	necessary operating environment settings so that the device
	will be recognized.

5-4PEN*KEYR 6642 Pen Computer User’s Guide

Image 59

Contents Pen Computer Acknowledgments FCC Computer Compliance Telephone Installation Warning Notices Only with the same or equivalent type Contents Software Included with the 6642 Pen Computer Before connecting peripherals Figures Introduction About this Manual SectionPEN*KEYR 6642 Pen Computer OverviewOverview Front View Power Button Speaker Power LEDBattery LED Pen Removal Pen StylusSide Views Infrared Communications Port Rear ViewBottom View Reset Switch Internal Battery Pack Charging Using the Pen Computer for the First Time Connecting the AC Adapter Startup System StartupInputting Text Pen Stylus InputSelecting an Item pointing Moving Items/Resizing WindowsPen Operation Connect Devices Using the External Floppy Drive/Port Expander Removing External Floppy Disk Drive/Port Expander Inserting and Removing Floppy Disks Handling Floppy DisksFormatting a Floppy Disk Software Included with Pen Computer General InformationWindows Windows 98 Help Help With Operating ProceduresKeyword ContentsHelp Regarding Items on Screen PEN*KEY Utility Tool 6PEN*KEYR 6642 Pen Computer User’s Guide Section Suspend SetupKeypad Assign Pen Calibration Pen Calibration Exiting the PEN*KEY Tool Checking the Version of the PEN*KEY ToolCIC Handwriting Recognition On Screen Keyboard Right Mouse Button SettingBattery Charge Battery UseCharging Internal Battery Pack Attaching the Expansion Battery Pack Attaching the Expansion Battery Drop the Battery into Tabs, Slide it to the Right Confirming the Remaining Battery Pack Capacity Remaining Battery Pack Capacity DisplaySection Low Battery Warning Charging and Operating Times Pen computer is usingBattery Disposal Before connecting peripherals Connecting Peripheral EquipmentPeripheral Equipment Audio I/O ConnectorsFloppy Drive/Port Expander Keyboard/Mouse USB ConnectionSvga Port Switching the DisplayRS-232C Installing a Printer DriverPrinter Preparing the 6642 and the Target Device Settings for Infrared CommunicationIrDA Communications Communication with a PC Logical PortDisabling IR Communication PC Card Slot Removing a PC Card Modem Setting Communications Software Connecting the ModemSetting Communications Information Troubleshooting Problems on Start-up Problems with Display Problems with Floppy Disk Problems with Hard DiskProblems with Peripherals Problems with Touch Panel6PEN*KEYR 6642 Pen Computer User’s Guide Problems with Communications Other Problems Customer Response Center Factory ServiceWeb Site Bulletin Board Service