Intermec 6642 manual RS-232C, Installing a Printer Driver

Page 61

Connecting Peripheral Equipment

SECTION 5

Printer

You can connect a printer to a parallel port of the external floppy drive/port expander.

"NOTE:Read the printer manual before setting up the printer.

Check the setup utility for the LPT port settings before installing a printer driver.

Installing a Printer Driver

To use a printer, you need to install a printer driver.

1.In Windows Start menu, select Settings-Printers.

2.Double-tap Add Printer. The Add Printer appears.

3.Tap Next.

4.Confirm Local printer is selected and tap Next.

5.Select the manufacturer and the printer, and click Next. If you cannot find the model name of your print* er you will have to install the printer driver included with your printer. See your printer manual for de* tails.

6.Select LPT1 and tap Next.

7.Make sure the printer name is correct and tap Next.

8.Decide whether to print a test page, and tap Finish. Before printing a test page, make sure the printer is powered up and on line.

RS–232C

An RS-232C serial device, such as a modem or scanner can be connected to the 6642. The serial port is available on the exter* nal floppy drive/port expander. Check the setup utility for serial port settings on the 6642 and consult the user manual before connecting the device.

5-6PEN*KEYR 6642 Pen Computer User’s Guide

Image 61

Contents Pen Computer Acknowledgments FCC Computer Compliance Telephone Installation Warning Notices Only with the same or equivalent type Contents Software Included with the 6642 Pen Computer Before connecting peripherals Figures Introduction About this Manual SectionPEN*KEYR 6642 Pen Computer OverviewOverview Front View Power Button Battery LED Power LEDSpeaker Pen Removal Pen StylusSide Views Infrared Communications Port Rear ViewBottom View Reset Switch Internal Battery Pack Charging Using the Pen Computer for the First Time Connecting the AC Adapter Startup System StartupSelecting an Item pointing Pen Stylus InputMoving Items/Resizing Windows Inputting TextPen Operation Connect Devices Using the External Floppy Drive/Port Expander Removing External Floppy Disk Drive/Port Expander Inserting and Removing Floppy Disks Handling Floppy DisksFormatting a Floppy Disk Windows General InformationSoftware Included with Pen Computer Windows 98 Help Help With Operating ProceduresKeyword ContentsHelp Regarding Items on Screen PEN*KEY Utility Tool 6PEN*KEYR 6642 Pen Computer User’s Guide Section Suspend SetupKeypad Assign Pen Calibration Pen Calibration Exiting the PEN*KEY Tool Checking the Version of the PEN*KEY ToolCIC Handwriting Recognition On Screen Keyboard Right Mouse Button SettingBattery Charge Battery UseCharging Internal Battery Pack Attaching the Expansion Battery Pack Attaching the Expansion Battery Drop the Battery into Tabs, Slide it to the Right Confirming the Remaining Battery Pack Capacity Remaining Battery Pack Capacity DisplaySection Low Battery Warning Charging and Operating Times Pen computer is usingBattery Disposal Before connecting peripherals Connecting Peripheral EquipmentPeripheral Equipment Floppy Drive/Port Expander ConnectorsAudio I/O Keyboard/Mouse USB ConnectionSvga Port Switching the DisplayPrinter Installing a Printer DriverRS-232C IrDA Communications Settings for Infrared CommunicationPreparing the 6642 and the Target Device Disabling IR Communication Logical PortCommunication with a PC PC Card Slot Removing a PC Card Modem Setting Communications Information Connecting the ModemSetting Communications Software Troubleshooting Problems on Start-up Problems with Display Problems with Floppy Disk Problems with Hard DiskProblems with Peripherals Problems with Touch Panel6PEN*KEYR 6642 Pen Computer User’s Guide Problems with Communications Other Problems Customer Response Center Factory ServiceWeb Site Bulletin Board Service