HandHeld Entertainment SV Series manual Mode 12 LED Operation, ~LV12

d.ISO Defects grade programmable (~PB806xxx000)

e.ISO Decodability grade programmable (~PB802xxx100)

f.Symbol Contrast grade programmable (~PB804xxx100)

g.No Read (if edge sync is received)

h.Number of codes per sync programmable (~LN##, ~LZ##)

i.Overall ISO Grade (Programmable, ~LAxx)

j.Symbology modulo check digit

Mode 12 LED Operation

1.LED1 will turn on if Ports 1-4 go active due to ISO, contrast, or quiet zone failure

2.LED2 will turn on if Ports 1-4 go active due to a partial or no read condition

Note: Both LEDs can be on in cases where multiple bar codes are analyzed in a sync period.

SV Commands Important to Mode 12

This system is operating in a “mode” rather than fully programmable logic. The port activation parameters are programmable via the ~PB8 rather than ~PB1, ~PB2, etc. for each individual port. Other commands, such as mode commands are also available. The commands most useful for this system application are described below.

~LV12

This command sets this mode of operation.

~Lp0

This command turns off all partial decode logic at the decoder level

~Lp1

This command turns on partial decode logic at the decoder level

~LQ1

This command allows partial decodes to activate the output ports

~LQ0

This command disables partial decodes to activate output ports.

Quick Check® SV Series User’s Guide 6 - 37