Datamax M-4206 manual Media Sensor Adjustment, Sensor Eye Mark Position

3.3Media Sensor Adjustment

The Media Sensor needs to be positioned so that the printer can detect the presence of media and the top-of-form (except for continuous stock, where the TOF is set through the front panel, (see ‘CONT FORM LENGTH’, Section 4.5.2). To adjust:

nWith media loaded, as described in Section 3.2, grasp the Slide Tab and move the Sensor Eye Mark into position over media according to the table below.

oIf loading media, return to the media loading instructions.

Media Sensor Selection and Adjustment

Media Type	Sensor Eye Mark Position	Sensing
		Required*
Die-cut	Near the middle of the label	Gap
Notched	Centered over the notch	Gap
Reflective	Centered over the black mark	Reflective
Continuous	Near the middle of the media	Continuous

*See Section 4.5.2 for Sensor Type selection.

12 M-4206