Datamax M-4206 manual Printhead Replacement, Removal

Page 48

5.5Printhead Replacement

Removal:

;Note: Printheads are fragile; use extreme care when handling and never use a sharp object on the surface. If you have questions, contact a qualified technician or Datamax Technical Support before proceeding.

1.Touch a bare metal part of the printer’s frame to discharge any static electricity that may be present on your body.

2.Turn ‘Off’ and unplug the printer. Open the cover; if ribbon is installed, remove it.

3.With the printhead locked in the down position, loosen the Printhead Mounting Screw (it will remain in the assembly).

4.Unlatch the Printhead Assembly. While holding the Printhead, raise the assembly. Disconnect the two cables and then remove the old Printhead.

5.While carefully holding the new Printhead, connect both cables.

6.Position the Printhead onto the Locating Pins in the Printhead Assembly and secure in place with the Printhead Mounting Screw (do not over-tighten).

7.Clean the Printhead (see Section 5.1).

8.Reload ribbon (if removed), lower the printhead assembly, and rotate the printhead latch back, into the locked position.

9.Use the Darkness Adjustment to match the print contrast of the new printhead to that of the old printhead (see Section 5.6).

42

M-4206

Image 48
Contents Operator’s Manual Copyright Information Agency Compliance and Approvals Important Safety Instructions Printer Overview Troubleshooting Introduction Standard Features About this PrinterOptional Features Thermal Transfer4206 Before Using the Printer Removing the PackagingInspecting the Printer Additional RequirementsConnecting the Printer Power ConnectionInterface Connection USB ConnectionLoading Media 4206 4206 Media Sensor Adjustment Sensor Eye Mark PositionLoading Ribbon 4206 Ribbon Routing Coated Side In & Coated Side Out Normal Mode LightsNormal Mode Button Functions ButtonsExpress Setup Mode Button Functions Printer Setup Mode Button Functions To change Printer SetupPrinter Setup Menu List Menu Item Values Numbers ItemsMenu Items and Values Media Type Sensor TypeControl Codes Form Length Align Length Stop Location Step by Step Modification of the Printer Setup New 19200 Baud Rate Label Alignment Label Alignment = YESLabel Alignment = Auto Label Alignment = noLabel Alignment Troubleshooting Problem Possible Cause SolutionIncorrect. Pressing Not correct. The default Calibration Mode Button Functions To perform CalibrationAuto Media Sensor Calibration Manual Media Sensor Calibration Database Configuration and Dot Check Labels Internal LabelsGood Dot Check Label Test Label To print the Test LabelHex Dump Label To print the Hex Dump LabelArea Method Interval Cleaning the Printhead Media Width Adjustment Printhead Burn Line Adjustment Printhead Pressure Adjustment Printhead Replacement RemovalDarkness Adjustment Resetting to the Factory DefaultsDownloading Firmware and Fonts Troubleshooting Tips Problem SituationUnacceptable print quality Skips every other label Label advances 16 inches before a fault indication Mechanical PrintingMedia/Ribbon CommunicationsFonts Embedded Bar CodesApproved Media Side View Top View4206 Ascii Control Code Chart XON Embedded Fonts and Barcodes Font Valid Ascii Characters decimal Use with RecordAlphanumeric, upper and lower Font 6 62-character alphanumeric, uppercase 4206 Barcodes Bar Code Type Length Check Valid Ascii Characters SumFIM Barcode a Code 3 Barcode I Codabar Barcode T Telepen Barcode v FIM Bar Code W1c DataMatrix Printer Thermal PrintheadWarranty Service Procedures General Warranty ProvisionsLimitation of Liability Glossary 4206 4206 4206