Datamax M-4206 manual Before Using the Printer, Removing the Packaging

Page 11

2.0Before Using the Printer

Removing the Packaging

Inspect the shipping container(s) for damage; if damage is evident notify the shipping company to report the nature and extent of the damage.

The printer is carefully packaged to avoid any damage during transit. In order to operate the printer you will need to remove the packaging materials (i.e., tape and foam) that were placed in the printer for shipment. Complete the following steps prior to connecting power or attempting to load media.

¾Ensure that the arrow on the box is pointing up, and then open the box.

¾Remove the top piece of packing foam.

¾Lift the printer from the box.

¾Remove the printer from the plastic bag.

¾Remove any tape or additional packing foam from the inside of the printer.

; Note: It is a good idea to save all packaging materials in the event that shipping the printer is ever required.

M-4206

5

Image 11

Contents Operator’s Manual Copyright Information Agency Compliance and Approvals Important Safety Instructions Printer Overview Troubleshooting Introduction About this Printer Standard FeaturesThermal Transfer Optional Features4206 Removing the Packaging Before Using the PrinterAdditional Requirements Inspecting the PrinterPower Connection Connecting the PrinterUSB Connection Interface ConnectionLoading Media 4206 4206 Sensor Eye Mark Position Media Sensor AdjustmentLoading Ribbon 4206 Ribbon Routing Coated Side In & Coated Side Out Lights Normal ModeButtons Normal Mode Button FunctionsExpress Setup Mode Button Functions To change Printer Setup Printer Setup Mode Button FunctionsMenu Item Values Numbers Items Printer Setup Menu ListMedia Type Sensor Type Menu Items and ValuesControl Codes Form Length Align Length Stop Location Step by Step Modification of the Printer Setup New 19200 Baud Rate Label Alignment = YES Label AlignmentLabel Alignment = no Label Alignment = AutoProblem Possible Cause Solution Label Alignment TroubleshootingIncorrect. Pressing Not correct. The default To perform Calibration Calibration Mode Button FunctionsAuto Media Sensor Calibration Manual Media Sensor Calibration Internal Labels Database Configuration and Dot Check LabelsGood Dot Check Label To print the Test Label Test LabelTo print the Hex Dump Label Hex Dump LabelArea Method Interval Cleaning the Printhead Media Width Adjustment Printhead Burn Line Adjustment Printhead Pressure Adjustment Removal Printhead ReplacementResetting to the Factory Defaults Darkness AdjustmentDownloading Firmware and Fonts Problem Situation Troubleshooting TipsUnacceptable print quality Skips every other label Label advances 16 inches before a fault indication Printing MechanicalEmbedded Bar Codes Media/RibbonCommunications FontsSide View Top View Approved Media4206 Ascii Control Code Chart XON Font Valid Ascii Characters decimal Use with Record Embedded Fonts and BarcodesAlphanumeric, upper and lower Font 6 62-character alphanumeric, uppercase 4206 Bar Code Type Length Check Valid Ascii Characters Sum BarcodesFIM Barcode a Code 3 Barcode I Codabar Barcode T Telepen Barcode v FIM Bar Code W1c DataMatrix Thermal Printhead PrinterLimitation of Liability Warranty Service ProceduresGeneral Warranty Provisions Glossary 4206 4206 4206