9) CONTROL CODES | 10) CONT FORM LENGTH | ||
Allows code selection listed in | Sets the page (label) size when the | ||
Programmer’s manual. | ‘SENSOR TYPE’ is set to continuous | ||
Possible Values: | media. |
| |
Possible Values: | |||
* (STD) Standard Codes | |||
Range: 0 – 9999; default = *100 | |||
(ALT) Alternate Codes | |||
| (Units = .01 inch) | ||
|
| ||
11) OOS MAXVOLT | 12) TOF GAIN | ||
Sets the media sensor level for the | Sets media sensor Top of Form gain | ||
Out Of Stock condition. | value. |
| |
Possible Values: | Possible Values: | ||
Range: 0 – 16; nominal = *2 | Range: 0 – 15; nominal = *10 | ||
(Units = .1 volt) |
|
| |
|
| ||
13) TOF DELTA | 14) TOF LOW | ||
Sets the minimum media sensor | Sets the minimum media sensor reading | ||
change required to signify a label | for paper (gap/notch) or mark | ||
gap or mark. | (reflective). | ||
Possible Values: | Possible Values: | ||
Range: 0 – 50; nominal = *10 | Range: 0 – 50; nominal = *0 | ||
(Units = .1 volt) | (Units = 0.1 volt) | ||
|
| ||
15) LABEL WIDTH | 16) SCALABLE FONT | ||
Sets the label width. | Sets the number of memory blocks to | ||
Possible Values: | allocate for scalable fonts. | ||
Possible Values: | |||
Range: 75 – 426; default = *426 | |||
|
| ||
(Units = .01 inch) | Range: 0 – 128; default = *64 | ||
| (Units = 4K Bytes) | ||
|
| ||
17) INTERNAL MODULE | 18) LABEL ALIGNMENT | ||
Sets the number of memory blocks to | Sets the label alignment method (see | ||
allocate for the internal RAM | Section 4.6). | ||
module. | Possible Values: | ||
Possible Values: | |||
YES | (user manually determines | ||
| |||
Range: 0 – 128; default = *128 |
| ‘ALIGN LENGTH’) | |
(Units = 4K Bytes) | AUTO (printer determines ‘ALIGN | ||
|
| LENGTH’) | |
| * NO | (no Label Alignment used) | |
22 |
|