3.2 Part Descriptions
(1)I/F connector (Interface connector)
Printer can be connected to the signal line of various kinds of host via a cable. Please ensure that both the printer and the host are turned off before connecting or disconnecting. This connector also has a power input.
Connect the FG terminal to the earth. Cable connected differs with the interface.
(2) | FEED switch | Paper is fed while this switch is pressed and held. |
|
| Turning the printer power on while pressing and holding |
|
| this switch causes |
|
| In the memory switch setting mode, various kinds of setting |
|
| are available by pressing this switch. |
(3) | Power lamp | Lights/blinks when the paper has become scarce or run out. |
|
| The lighting status depends on the memory switch setting. |
|
| Blinks when mechanism error or the like occurs depending |
|
| on the condition of memory switch setting. |
(4) | Knob | Used to set paper or to open the front cover when setting |
|
| or replacing paper. |
(5) | Ribbon cover | Opened/closed when replacing the ink ribbon cassette. Can |
|
| open when you pull the left side of the front face toward |
|
| you. |
(6) | Paper holder | Printing paper is set and fixed here. |
|
| Insert the print paper into the paper inlet and then set the |
|
| paper. |
(7) | PE sensor | Detects no paper condition. |
(8) | PNE sensor | Detects |
|
| This function is enabled or disabled depending on the mode |
|
| or memory switch setting. |
(9) | DIP switch (SW1) | This switch allows basic initial setting. |
|
| Use this switch before turning on the printer. |
(10) | Back switch | Press this switch to use special function. |
|
| This switch is not used in normal operation. |
(11) | POWER lamp | Lighted when power is turned ON. Blinks at the occurrence |
|
| of error or during memory switch setting. |
(12) | Mounting bracket | A bracket to hold the printer body. |
|
| Hold the printer to the panel or the like by using the two |
|
| screws supplied. |
— 12 —