NOTE
•Set the print paper in the correct direction.
•When closing the front panel, be sure not to catch paper. Otherwise, paper jam, etc. may occur.
•Do not start printing without print paper properly held in the paper holder; otherwise, paper jam or the like may occur.
•While replacing the paper, do not send data from the host.
•Do not pull the paper in reverse direction of paper feed. This may cause abnormality of print head.
•In case the paper is set at as skew angle, paper jam may occur. If paper jam occurs, turn off the power switch and pull out the jammed paper slowly straightforward in the paper feed direction.
•Note that if “Auto clear after paper setting”is set and data is present in the print buffer, print operation starts automatically after print paper is set.
•Do not use roll paper of φ50 mm or more. Otherwise, paper jam or the like may occur.
NOTES ON PAPER
Shape:
Use the roll paper with the beginning of winding (innermost end of the paper roll) treated as follows:
(1)No fold and well aligned to inside diameter.
(2)No flap
(3)Not pasted to the paper core (if any).
(4)No colored part facing PNE sensor (Otherwise, variations in PNE sensor detection may occur.)
Recommended paper:
Paper roll diameter
(1)With core
Use paper core of f12 mm inner diameter and f18 mm outer diameter. Using paper core of greater than f18 mm or cone type may have effect on the PNE sensor.
(2)Without core
Start winding for printing at the position of f12 mm or more. The PNE sensor starts detection of PNE (Paper Near End) around f20 mm. If you use a roll paper without core, keep the paper remainder in mind.
If the start of winding is f12 mm or more, print paper may flip flop in the printer and may affect PNE sensor detection.
— 18 —