Citizen Systems CBM920II user manual I/F Cable Connection

Page 17

4.2I/F Cable Connection

(1)Hold the protruding section at the rear of the printer cover and lift in the direction indicated.

(1)Confirm that themain power supply, etc. are OFF.

(2)Prepare power supply satisfying the power voltage and current capacity having been specified in the specifications.

(3)Firmly connect, in appropriate direction, the power supply and the main body through using the attached cable. The connector is at the bottom of the main body as shown in the drawing. This cable is integrated with the communication cable. The power cable is larger than the communication cable, which is colored in red and in orange for +5V use and in black for GND.

(4)Connect a power supply cable to the power supply. Pay attention not to connect power supply cable in reverse polar.

NOTE

Be sure to connect power cord and interface cable in correct polarity.

Connecting cable in reverse polarity may cause damage not only to the printer but also to the host.

Hold the connector when connecting or disconnecting the power cord of interface cable.

PAPE	R
PAPE
FEED

1

2

19

20

— 14 —

Image 17

Contents DOT Matrix Printer Weee Mark Declaration of Conformity General Precautions Ordinarymaintenance Page Precautions for Installation Precautions for Handling Table of Contents External Dimensions Introduction FeaturesAccessories Type Power supplyType Classifications CBM-920II-24 CBM-920II-40 SpecificationsExternal Appearance External Appearance and Part DescriptionsPart Descriptions Rack Mounting OperationsI/F Cable Connection Opening/Closing of Front Panel Panel Opening/ClosingPaper Feeding Setting Ribbon CassetteSetting Paper Page Auto Loading Function Self-printing Function, Hexadecimal Printing Function Japan 920JPN International 920Intl Memory Switch SettingPage Contents of Memory Switch Setting CBM-920II 10 PNE, PE, Other errors State Clearing Lamp Status, I/F signal status, error, etcReturn Paper lamp Power lamp Signal line Special Functions Parallel Interface Connector Pin AssignmentPin Signal Name Description of Input/Output Signals Host Side Printer Side Electrical CharacteristicsTTL , Cmos Serial InterfaceDtrdata Terminal Ready Description of Input/Output SignalReceiving Control and Buffering Error DetectionDIP Switch Position DIP Switch SW1 SettingSwitch No Function Factory SettingSerial Interface Type Switch No Baud Rate Parity Factory Setting BpsList of Control Codes Symbol Code Function Emulation Hexadecimal CBM920 IDP3110Print Control Function Control Code Details SW1 Switch No.1SW2 Switch No.2 ABC Character Code Table CountryESC Page FF FF FF FF FF FF For 40-column model 3 4 5 6 41H 22H 55H 08H 41H 00H 41H Model CBM-920 emulation For manual setting, refer to 4.9 Setting Memory Switch Function Content of Setting Setting range of parameters n1 and n2 is as shown belowCode page table Character Code TablePage Page Page International Character Code Table External Dimensions