Citizen Systems CBM920II user manual Abc

Page 41

(3)Data Cancel (CAN) Command

With CAN (18H) code input, print data held within the line before input of the CAN code are all cancelled.

[Example of print data]

SO 123456 CAN ABC CR

[Results of Printing]

ABC

*As data “123456” are cancelled without the command “SO” cancelled, “ABC” is printed in lateral enlargement.

(4)Inverted Letter Assignment (DC2) Command

When data are input with DC2 (12H) attached at the beginning of a line (invalid when attached to any other place), data following are all printed in inverted letters. To cancel this, input either DC2 again or DC1 (initial setting.)

(5)Initial Setting (DC1) Command

With DC1 (11H) input, various conditions set after power supply are cancelled and the state as at supply of power is restored.

Content of the input buffer, however, is held unchanged.

(6)Continuous Paper Feed Assignment (ESC + “B”) Command

With ESC (1BH) +“B” (42H) + n code input, continuous paper feed at n-dot line is executed.

However, n allows continuous paper feed to be executed at even-numbered dot line in the range of 4 n 255. If n is specified otherwise, this command is cancelled.

When this command is entered, print data, if any, in the input buffer is printed. Print line (10-dot line) is included in the amount of line feed “n”; therefore, 4 n

9 provides a line space of “0”.

— 38 —

Image 41
Contents DOT Matrix Printer Weee Mark Declaration of Conformity General Precautions Ordinarymaintenance Page Precautions for Installation Precautions for Handling Table of Contents External Dimensions Introduction FeaturesAccessories Type Power supplyType Classifications CBM-920II-24 CBM-920II-40 SpecificationsExternal Appearance External Appearance and Part DescriptionsPart Descriptions Rack Mounting OperationsI/F Cable Connection Opening/Closing of Front Panel Panel Opening/ClosingPaper Feeding Setting Ribbon CassetteSetting Paper Page Auto Loading Function Self-printing Function, Hexadecimal Printing Function Japan 920JPN International 920Intl Memory Switch SettingPage Contents of Memory Switch Setting CBM-920II 10 PNE, PE, Other errors State Clearing Lamp Status, I/F signal status, error, etcReturn Paper lamp Power lamp Signal line Special Functions Parallel Interface Connector Pin AssignmentPin Signal Name Description of Input/Output Signals Host Side Printer Side Electrical CharacteristicsTTL , Cmos Serial InterfaceDtrdata Terminal Ready Description of Input/Output SignalReceiving Control and Buffering Error DetectionDIP Switch Position DIP Switch SW1 SettingSwitch No Function Factory SettingSerial Interface Type Switch No Baud Rate Parity Factory Setting BpsList of Control Codes Symbol Code Function Emulation Hexadecimal CBM920 IDP3110Print Control Function Control Code Details SW1 Switch No.1SW2 Switch No.2 ABC Character Code Table CountryESC Page FF FF FF FF FF FF For 40-column model 3 4 5 6 41H 22H 55H 08H 41H 00H 41H Model CBM-920 emulation For manual setting, refer to 4.9 Setting Memory Switch Function Content of Setting Setting range of parameters n1 and n2 is as shown belowCode page table Character Code TablePage Page Page International Character Code Table External Dimensions