Citizen Systems CBM920II DIP Switch SW1 Setting, DIP Switch Position, Parallel Interface Type

Page 37

7.DIP SWITCH (SW1) SETTING

7.1DIP Switch Position

DIP switch (SW1) is located at the back of the printer as shown in the figure below. The polarity and part of the function of the switch differs depending on the interface. For memory switch setting, refer to “4.9 Setting Memory Switches”.

NOTE

Before setting, turn the printer power off.

Do not use edged object, such as a pen, to change the switch.

Serial

ON


	1		2		3		4		5		6		7		8
Parallel

ON


	1		2		3		4

7.2 Parallel Interface Type

Switch No.	Function	OFF	ON	Factory Setting
1	Character direction	Normal	Inverted	OFF
2 (920)*	CR command	Ignore CR	CR + LF	OFF
2 (3110)*	CR command	CR	LF	OFF
3	RESET in	Disable	Enable	ON
4	Memory switch	Disable Setting	Enable Setting	OFF

*: Difference may occur in accordance with the emulation set by the memory switch.

After setting DIP switch No. 4 to ON, turning the printer power on with the SEL switch pressed and held causes the printer enter the Manual memory switch setting mode. After manual setting mode, be sure to set this switch to OFF.

— 34 —

Image 37

Contents DOT Matrix Printer Weee Mark Declaration of Conformity General Precautions Ordinarymaintenance Page Precautions for Installation Precautions for Handling Table of Contents External Dimensions Accessories FeaturesIntroduction Type Classifications Power supplyType CBM-920II-24 CBM-920II-40 SpecificationsExternal Appearance External Appearance and Part DescriptionsPart Descriptions Rack Mounting OperationsI/F Cable Connection Opening/Closing of Front Panel Panel Opening/ClosingPaper Feeding Setting Ribbon CassetteSetting Paper Page Auto Loading Function Self-printing Function, Hexadecimal Printing Function Japan 920JPN International 920Intl Memory Switch SettingPage Contents of Memory Switch Setting CBM-920II 10 PNE, PE, Other errors Return Paper lamp Power lamp Signal line Clearing Lamp Status, I/F signal status, error, etcState Special Functions Pin Signal Name Connector Pin AssignmentParallel Interface Description of Input/Output Signals Host Side Printer Side Electrical CharacteristicsTTL , Cmos Serial InterfaceDtrdata Terminal Ready Description of Input/Output SignalReceiving Control and Buffering Error DetectionDIP Switch Position DIP Switch SW1 SettingSwitch No Function Factory SettingSerial Interface Type Switch No Baud Rate Parity Factory Setting BpsPrint Control Function Symbol Code Function Emulation Hexadecimal CBM920 IDP3110List of Control Codes SW2 Switch No.2 SW1 Switch No.1Control Code Details ABC Character Code Table CountryESC Page FF FF FF FF FF FF For 40-column model 3 4 5 6 41H 22H 55H 08H 41H 00H 41H Model CBM-920 emulation For manual setting, refer to 4.9 Setting Memory Switch Function Content of Setting Setting range of parameters n1 and n2 is as shown belowCode page table Character Code TablePage Page Page International Character Code Table External Dimensions