Citizen Systems CBM920II user manual Operations, Rack Mounting

Page 16

4.OPERATIONS

4.1Rack Mounting

(1)As in the following drawing, insert themain body into the rack.

(2)Inserting the main body on the rear side with mounting bracket, fasten thema in body with the screws.

Pay attention not to tighten screws excessively.

(3)After fixing, confirm opening/closing of the front panel, etc..

NOTE

The mount (rack, etc.) shall be about 1 to 3 mm in thick.

Use the material that is free from deformation for the mount when the printer is placed to the mount.

Tighten the screws taking not to give deformation to the printer, bracket, or mount. Excessive tightening of screw not only provides stress on the printer but also causes failure in the printer.

Recommended mounting hole dimensions 109 (W) x 62 (H) mm

Tolerance:+0 mm, -0.5 mm

— 13 —

Image 16

Contents DOT Matrix Printer Weee Mark Declaration of Conformity General Precautions Ordinarymaintenance Page Precautions for Installation Precautions for Handling Table of Contents External Dimensions Accessories FeaturesIntroduction Type Classifications Power supplyType Specifications CBM-920II-24 CBM-920II-40External Appearance and Part Descriptions External AppearancePart Descriptions Operations Rack MountingI/F Cable Connection Panel Opening/Closing Opening/Closing of Front PanelSetting Ribbon Cassette Paper FeedingSetting Paper Page Auto Loading Function Self-printing Function, Hexadecimal Printing Function Memory Switch Setting Japan 920JPN International 920IntlPage Contents of Memory Switch Setting CBM-920II 10 PNE, PE, Other errors Return Paper lamp Power lamp Signal line Clearing Lamp Status, I/F signal status, error, etcState Special Functions Pin Signal Name Connector Pin AssignmentParallel Interface Description of Input/Output Signals Electrical Characteristics Host Side Printer SideSerial Interface TTL , CmosDescription of Input/Output Signal Dtrdata Terminal ReadyError Detection Receiving Control and BufferingDIP Switch SW1 Setting DIP Switch PositionSwitch No Function Factory SettingSwitch No Baud Rate Parity Factory Setting Bps Serial Interface TypePrint Control Function Symbol Code Function Emulation Hexadecimal CBM920 IDP3110List of Control Codes SW2 Switch No.2 SW1 Switch No.1Control Code Details ABC Country Character Code TableESC Page FF FF FF FF FF FF For 40-column model 3 4 5 6 41H 22H 55H 08H 41H 00H 41H Model CBM-920 emulation For manual setting, refer to 4.9 Setting Memory Switch Setting range of parameters n1 and n2 is as shown below Function Content of SettingCharacter Code Table Code page tablePage Page Page International Character Code Table External Dimensions