Citizen Systems CBM920II user manual Self-printing Function, Hexadecimal Printing Function

Page 23

4.8 Self-printing Function, Hexadecimal Printing Function

Turning the printer power on while pressing and holding the FEED switch causes the following state.

Before operating the FEED switch, confirm that the DIP switch (SW1) No. 4 at the back of the printer is set to OFF.

Self-printing function

Prints model name, version, initial setting state, etc.

• Hexadecimal printing function

Prints all data sent from the host in hexadecimal code. This mode lasts till the printer is turned off.

(1)Self-printing function

Turn the printer power on with the FEED switch pressed and held.

Release the FEED switch in 3 seconds after printer power on, and self-printing starts. After self-printing, normal printing state is restored.

(2)Hexadecimal printing function

Turn the printer power on with the FEED switch pressed and held for approx. 6 seconds and then release the FEED switch. The printer prints “Hexadecimal Dump” and then stops.

The printer prints data sent from the host by converting it to hexadecimal code. If the data received last is less than one line, press the FEED switch to print the received data. Print data for one line differs depending on the specification (number of digits).

Example of Self-print:

Example of Hexadecimal print:

 

 

 

— 20 —

Image 23
Contents DOT Matrix Printer Weee Mark Declaration of Conformity General Precautions Ordinarymaintenance Page Precautions for Installation Precautions for Handling Table of Contents External Dimensions Introduction FeaturesAccessories Type Power supplyType Classifications CBM-920II-24 CBM-920II-40 SpecificationsExternal Appearance External Appearance and Part DescriptionsPart Descriptions Rack Mounting OperationsI/F Cable Connection Opening/Closing of Front Panel Panel Opening/ClosingPaper Feeding Setting Ribbon CassetteSetting Paper Page Auto Loading Function Self-printing Function, Hexadecimal Printing Function Japan 920JPN International 920Intl Memory Switch SettingPage Contents of Memory Switch Setting CBM-920II 10 PNE, PE, Other errors State Clearing Lamp Status, I/F signal status, error, etcReturn Paper lamp Power lamp Signal line Special Functions Parallel Interface Connector Pin AssignmentPin Signal Name Description of Input/Output Signals Host Side Printer Side Electrical CharacteristicsTTL , Cmos Serial InterfaceDtrdata Terminal Ready Description of Input/Output SignalReceiving Control and Buffering Error DetectionFactory Setting DIP Switch SW1 SettingDIP Switch Position Switch No FunctionSerial Interface Type Switch No Baud Rate Parity Factory Setting BpsList of Control Codes Symbol Code Function Emulation Hexadecimal CBM920 IDP3110Print Control Function Control Code Details SW1 Switch No.1SW2 Switch No.2 ABC Character Code Table CountryESC Page FF FF FF FF FF FF For 40-column model 3 4 5 6 41H 22H 55H 08H 41H 00H 41H Model CBM-920 emulation For manual setting, refer to 4.9 Setting Memory Switch Function Content of Setting Setting range of parameters n1 and n2 is as shown belowCode page table Character Code TablePage Page Page International Character Code Table External Dimensions