Citizen Systems CBM920II user manual CBM-920II

NO.	Setting items	Options	Value*1	Printout of	Factory
	(Printout in the lower)			option	setting
8	PE output at PNE	Valid	0	Enable	●
	PNE Peout	Invalid	1	Disable
8	Communication data bit length selection	8 bits	0	8 bits	●
	Bit Length	7 bits	1	7 bits
9	I/F, LED state at PNE	I/F and LED	0	I/F+LED	●
	PNE Signal *8	I/F only	1	I/F only
		LED only	2	LED only
A	BUSY at FEED switch ON	Invalid	0	Disable	●
	FEED SW Busy	valid	1	Enable
B	Auto loading	Short (Few lines)	0	Short	●
	AutoLoad	Long (Approx 2 times)	1	Long
		Invalid	2	Disable
C	Clear after auto loading	FEED SW	0	FEED SW	●
	AL recover	Auto	1	Auto
D	Supply voltage check	At Power ON	0	PowerON	●
	Power Check	Always	1	Always
E	Paper lamp	CBM-920 Emulation	0	CBM-920	●
	Paper LED	CBM-920II	1	CBM-920II

*1: Value in () is the one printed as the initial setting items in self-printing.

*2: Initial setting value of overseas specification (F model)

*3: Initial setting value of domestic specification (J model)

*4: Setting item of parallel I/F (P model)

*5: Setting item of serial I/F (R model)

*6: In the offline state, pressing the FEED switch once with power ON sets the online state.

*7: Only parallel I/F (P mode) functions

Standard: Clear after confirming the start of STB signal.

CBM-920: Clear after completion of storing data to the input buffer.

*8: Indicates that I/F outputs BUSY at the detection of PNE. LED indicates PAPER lamp.

For the setting of DIP switches, refer to “7. Setting DIP Switches”.

— 24 —