Citizen Systems PPU-231II manual See Also

(3) Status caused by an error (when n = 3 is specified)

Bit	Status	Hex.	Decimal
0	Unused	00	0
1	Unused	02	2
	No Black mark detection error occurred	00	0
2	(only when “Black mark” is selected).
	A Black mark detection error occurred	04	4
	(only when “Black mark” is selected).
3	Auto cutter error not occurred	00	0
	Auto cutter error occurred	08	8
4	Unused	10	16
5	Unrecoverable error not occurred	00	0
	Unrecoverable error occurred	20	32
6	Auto recovery error not occurred	00	0
	Auto recovery error occurred	40	64
7	Undefined	00	0

Bit 3: If this error occurred because of a paper jam, for example, remove the cause of the error, and then DLE ENQ n (1 n 2) can be used to recover from the error. However, it is not possible to recover from any error due to a circuit problem (e.g., broken wire).

Bit 6: If a head overheat error is detected, the printing is stopped until the head temperature falls. At this time, bit 6 = “1”.

(4) Continuous paper detector status (When n = 4 is specified)

	Bit	Status	Hex.	Decimal
	0	Unused	00	0
	1	Unused	02	02
	2	Paper found by Paper Near-end Sensor 1	00	0
		Paper not found by Paper Near-end Sensor 1	04	4
	3	Paper found by Paper Near-end Sensor 2	00	0
		Paper not found by Paper Near-end Sensor 2	08	8
	4	Unused	10	16
	5	Paper found by Paper-end Sensor	00	0
		Paper not found by Paper-end Sensor	20	32
	6	Paper found by Presenter Sensor	00	0
		Paper not found by Presenter Sensor	40	64
	7	Unused	00	0
[See Also]	DLE ENQ, GS a, GS r

— 12 —