Citizen Systems PPU-231II manual GS ! n, Horizontal Magnification, Vertical Magnification

GS ! n

[Function]	Specifying the character size
[Code]	<1D>H<21>H<n>
[Range]	0	n 255, where:
	1	vertical magnification	8,
	1	horizontal magnification	8

[Outline]	Specifies the character size			(Vertical and horizontal
	magnification).
	Bit	Function		Value
			Hex. Number		Decimal Number
	0
	1	Vertical magnification		Refer to Table 2, “Vertical
	2	specification		Magnification”.
	3
	4
	5	Horizontal magnification		Refer to Table 1, “Horizontal
	6	specification		Magnification”.
	7

Table 1 Horizontal Magnification

Hex.	Decimal	Magnification
00	0	1 ⋅ (Standard)
10	16	2 ⋅ (Double width)
20	32	3 ⋅
30	48	4 ⋅
40	64	5 ⋅
50	80	6 ⋅
60	96	7 ⋅
70	112	8 ⋅

Table 2 Vertical Magnification

Hex.	Decimal	Magnification
00	0	1 ⋅ (Standard)
01	1	2 ⋅ (Double height)
02	2	3 ⋅
03	3	4 ⋅
04	4	5 ⋅
05	5	6 ⋅
06	6	7 ⋅
07	7	8 ⋅

[Caution]	• This command works for all ANK characters except for HRI
	characters.
	• This command is ignored if either the vertical magnification
	or horizontal magnification is out of the defined range.
	• In STANDARD MODE, the vertical direction is defined as the
	paper feed direction, and the horizontal direction is defined as
	the direction perpendicular to the paper feed. These definitions
	are, therefore, interchanged when 90°-right-turned characters
	are specified.
	• In PAGE MODE, the vertical direction means the top-bottom
	direction of each character. The horizontal direction means the
	side-to-side direction of each character.

— 53 —