GS | V | m ......... (1) |
GS | V | m n ..... (2) |
|
|
|
[Function] | Cutting the paper |
| |
[Code] | (1) <1D>H<56>H<m> |
| |
| (2) <1D>H<56>H<m><n> |
| |
[Range] | (1) m = 0, 1, 48, 49 |
| |
| (2) m = 65, 66 |
| |
| 0 n 255 |
| |
[Outline] | Performs the specified paper cutting. | ||
|
|
|
|
| m |
| Function |
| 0,1,48,49 | Paper cut (full cut) (Leaving a bridge area uncut) | |
| 65,66 | Paper feed by “cut position + {n ⋅ basic calculation | |
| pitch}”and paper cut (full cut) (Leaving a bridge area uncut) | ||
|
| ||
[Caution] |
|
| |
• Fully cut for the label sheet specs. | |||
| • In STANDARD MODE, this command only works when it is | ||
| entered at the beginning of a line. | ||
| For (1): |
|
|
| • A partial cut (Leaving a bridge area uncut) is executed. | ||
| For (2): |
|
|
| • If n = 0, the paper is fed to the cut position, and then cut. If n | ||
| ≠ 0, the paper is fed by “n ⋅ | basic calculation pitch” inches | |
past the cut position, and then cut.
• The basic calculation pitch is set by GS P.
The paper feed amount is calculated with the vertical basic calculation pitch (y).
A fraction resulting from the calculation is corrected with the minimum pitch of the mechanism, and the remainder is omitted.
— 72 —