Citizen CLP-7401, CLP-7001 Media Handling When Using Front Sensors, Specification of paper

Chapter 3 Paper and Ribbon

2Media Handling (When Using Front Sensors)

The front sensors consist of the transparent-type and reflective-type photosensors and the position of a label or tag is detected as follows:

Transparent-type photosensor: Detects paper gap between labels and tag paper notch.

Reflective-type photosensor: Detects black line.

Note: Check that the adjustable sensor is set to ‘AJSensOF.’ (See Chapter 2.)

•Specification of paper

For dimensions of paper gap between labels, tag paper (label paper) notch and black line, see figure.

		Minimum	value mm (in)	Maximum value mm (in)
A	Label width	7.62	(0.3)	118.00	(4.65)
B	Liner width	25.40	(1.0)	118.00	(4.65)
C	Label left edge position	0		2.54	(0.10)
D	Label paper gap length	2.54	(0.10)	2539.00	(99.96)
E	Label length	2.54	(0.10)	2539.00	(99.96)
F	Label pitch	5.08	(0.20)	2539.00	(99.96)
G	Liner thickness	0.06	(0.0025)	0.125	(0.0049)
H	Paper thickness	0.06	(0.0025)	0.25	(0.01)
I	Notch right end position	8.3	(0.32)	11	(0.43)
J	Notch left end position	0		4.7	(0.19)
K	Notch length	2.54	(0.10)	17.80	(0.70)
L	Black line right end position	15.00	(0.59)	–
M	Black line left end position	0		1.5	(0.06)
N	Black line width	3.18	(0.125)	17.80	(0.70)
Note:	• Paper having both label paper gap and black line should use the paper -gap sensor.
	• Fanfold should use the paper-gap sensor.

Size of paper

Printable area

Label paper	Continuous paper
	Notch detection	Black line detection
Label		Printable
		area
Label
		Black line
		OD value: 1.5 or
		more
Label		Carbon black ink
Using paper gap	Using paper gap	Using black line
adjustment sensor	adjustment sensor	adjustment sensor

Direction of paper feed

2.5mm	104.0mm	(11.5mm)
Left margin	Printable area	Right margin

35