Citizen CLP-7001, CLP-7401, CLP-7002 user manual Error Messages

		Chapter 5 TroubleShooting
		1 Error Messages
Indication	Description	Corrective actions
OverHeat	Head overheat	Wait until the head temperature goes down.
Cooling		When the temperature becomes low, the
		remaining printing resumes.
Stop	Stop key pressed	Enters a pause after displaying ‘Stop’ by the Stop
		command.
		If the Pause key is pressed, the printing will
		resume.
		If the Stop key is pressed again, the stored
		printing contents are discarded and ‘ON LINE’
		turns on.
Cancel	Stop command	Displays ‘Stop’ by the stop command, discards
	reception	the remaining printing contents, and enters
	(communication	pause.
	control)	If the Pause key is pressed, ‘ON LINE’ will turn
		on.
HeadOpen	Mechanism head	Close the mechanism head.
	open
PaperEnd	Paper end (paper out)	Install the paper.
PaperErr	Paper out (paper	Check the contents and clear with the Stop key.
	position cannot be	Correct the faulty setting of the paper detection
	detected)
		(paper gap, black line, continuous paper).
		Correct the faulty parameter for paper (max.
		length, continuous paper).
		Adjust the sensor or change to the paper that can
		accept the paper position detection.
		Specify the detection miss checking length with
		the M command.
		When the paper position cannot be detected
		during paper feeding by the specified length, it is
		judged error. Generally specify the length about
		three times the label length.
		In case of continuous paper, specify the label
		length with the C command.
		Difference between the maximum and minimum
		values of the sensor reading voltage must be 0.8
		V or more.
		Sensor adjustments and check of paper
		characteristic (voltage checking) can be
		performed with the Maintenance mode.

51