AMCC 9590SE, 9550SX manual Installing the 3ware CLI on Windows, Permissions Required to Run CLI

Chapter 1. Introduction to the 3ware Command Line Interface

Installing the 3ware CLI

Warning!

If you are using 3DM, as opposed to 3DM2, AMCC does not recommend installing both 3DM and CLI on the same system. Conflicts may occur. For example, if both are installed, alarms will be captured only by 3DM. You should use either CLI or 3DM to manage your 3ware RAID controllers.

This is not an issue for 3DM2. It can be installed with CLI.

(3DM was an earlier version of the software, which worked with 7/8000 model 3ware controllers. 3DM 2 works with the 9000-series.)

Installing the 3ware CLI on Windows

3ware CLI can be installed or run directly from the 3ware software CD, or the latest version can be downloaded from the 3ware web site, http://www.3ware.com. Online manual pages are also available in nroff and html formats. These are located in /packages/cli/tw_cli.8.html or

tw_cli.8.nroff.

To install 3ware CLI on Windows

•Copy the file tw_cli.exe to the directory from which you want to run the program.

CLI is located on the 3ware CD in the directory \packages\cli\windows

Note: CLI comes in both 32-bit and 64-bit versions. Be sure to copy the correct version for the version of the operating system you are using.

Permissions Required to Run CLI

To run CLI, you can be logged onto Windows with one of the following sets of permissions:

•Administrator

•User with administrator rights

•Domain administrator

•Domain user with Domain Admin or Administrator membership

Without the correct privileges, CLI will prompt and then exit when the application is executed.

4 3ware Serial ATA RAID Controller CLI Guide