Shell Object Commands
Enclosure Object Commands. Enclosure object commands provide information and perform actions related to a particular enclosure. For example, you can use enclosure object commands to see information about an enclosure and its elements (slots, fan, and temperature sensor elements).
Help Commands. Help commands allow you to display help information for all commands and attributes. For details, see “Help Commands” on page 91.
Shell Object Commands
Shell object commands are either applicable to all the controllers in the system (such as show, rescan, flush, commit), or redirect the focused object.
Syntax
focus object
show [attribute [modifier]] ver
alarms [reverse] diag
rebuild verify selftest
rescan flush commit
update fw=filename_with_path [force]
focus Object
The focus command is active in interactive mode only and is provided to reduce typing.
The focus command will set the specified object in focus and change the prompt to reflect this. This allows you to enter a command that applies to the focus, instead of having to type the entire object name each time.
For example, where normally you might type:
//hostname/c0/u0 show
if you set the focus to //hostname/c0/u0, the prompt changes to reflect that, and you only have to type show. The concept is similar to being in a particular location in a file system and requesting a listing of the current directory.
object can have the following forms:
//hostname/cx/ux specifies the fully qualified URI (Universal Resource Identifier) of an object on host hostname, controller cx, unit ux.
www.3ware.com | 23 |