AMCC 9500S, 9550SX, 9590SE, 9650SE manual Enclosure Object Commands, Ex show

Enclosure Object Commands

Enclosure Object Commands

Enclosure object commands provide information and perform actions related to a specific enclosure, such as /e0 and its elements, such as /e0/slot0. Enclosure object elements include slot, fan, and temperature sensor elements.

These commands are supported on the 9550SX, 9590SE, and 9650SE controllers, when an appropriate enclosure is used. The enclosure must use an integrated AMCC/3ware CCU (chassis control unit). (Check the 3ware web site for a list of chassis vendors that support enclosure services, as they become available.) If you purchased an enclosure directly from a third-party vendor, the appropriate EPCT (Enclosure Port Configuration Table) must have been downloaded to the controller in order to take advantage of these commands.

Note. Not all enclosure features may be available on enclosures that use an integrated AMCC/3ware CCU.

Syntax

/ex show	(9550SX, 9590SE, 9650SE only)
/ex show attribute [attribute ...] where attributes are:
controllersslotsfanstemp	(9550SX, 9590SE, 9650SE only)
/ex show all
/ex/slotx show	(9550SX, 9590SE, 9650SE only)
/ex/slotx show identify	(9550SX, 9590SE, 9650SE only)
/ex/slotx set identify=onoff	(9550SX, 9590SE, 9650SE only)
/ex/fanx show	(9550SX, 9590SE, 9650SE only)
/ex/tempx show	(9550SX, 9590SE, 9650SE only)

/ex show

This command shows summary information on the specified enclosure /ex. This report consists of four parts; the Enclosure summary listing the present elements, a Fan summary section listing of all present fans, a Temperature Sensor summary section listing of all present temperature sensors and a Slot summary section listing of slots and associated information for the specified enclosure.

www.3ware.com 87