Unit Object Commands
/cx/ux show storsave
This feature only applies to 9550SX, 9590SE, and 9650SE model controllers. This command reports the storsave policy on the unit.
For more information see, “/cx/ux set storsave=protectbalanceperform [quiet]” on page 70.
Example:
//localhost> /c0/u5 show storsave /c0/u5 Command Storsave Policy = protect
/cx/ux show identify
This feature only applies to 9550SX, 9590SE, and 9650SE model controllers.
This command is related to the /cx/ux set identify command. It shows the identify status of the specified unit (either on or off).
Example:
//localhost> /c0/u0 show identify /c0/u0 Identify status = on
/cx/ux show autoverify
This feature only applies to 9000 series controllers.
This command shows the current autoverify setting of the specified unit.
Example:
//localhost> /c0/u0 show autoverify /c0/u0 Auto Verify Policy = off
/cx/ux show cache
This command shows the current write cache state of the specified unit.
Example:
//localhost> /c0/u0 show cache /c0/u0 Cache State = on
www.3ware.com | 63 |