AMCC 9590SE, 9550SX, 9500S, 9650SE manual Cx/ux show ignoreECC, Cx/ux show volumes, Cx/ux show all

Chapter 2. CLI Syntax Reference

/cx/ux show ignoreECC

This feature only applies to 9000 series controllers.

This command shows the current setting of the ignoreECC policy for the specified unit.

Example:

//localhost> /c0/u0 show ignoreECC /c0/u0 Ignore ECC policy = off

/cx/ux show volumes

This feature only applies to 9000 series controllers.

This command reports the number of volumes in the specified unit. The number of volumes will normally be “1” unless the drive capacity exceeds 2TB and auto-carving is enabled.

Example:

//localhost> /c0/u0 show volumes /c0/u0 volume(s) = 1

/cx/ux show all

This command shows the current setting of all above attributes.

If the auto-carve policy was on at the time the unit was created and the unit is over the carve size, multiple volumes were created and are displayed at the end of the summary information. Similarly, if the unit was created using the 3ware BIOS utility 3BM and a size was entered in the Boot Volume Size field, multiple volumes were created and will be displayed. (Note that a volume created using the Boot Volume Size feature does not have to be used as a boot volume.)

Example:

//localhost> /c0/u1 show all /c0/u1 status = OK

/c0/u1 is not rebuilding, its current state is OK /c0/u1 is not verifying, its current state is OK /c0/u1 is not initializing, its current state is OK /c0/u1 Cache State = on

/c0/u1 volume(s) = 2 /c0/u1 name = myarray

/c0/u1 serial number = C6CPR7JMF98DA8001DF0 /c0/u1 Ignore ECC policy = on

/c0/u1 Auto Verify Policy = on

64 3ware Serial ATA RAID Controller CLI Guide