Opticon OPR 2001 specifications CTS, TXD signal timing, Modem

Page 22

Opticon

OPR 2001

Specifications Manual

CTS, TXD signal timing

When the CTS line (RTS signal of the host) is turned OFF while sending a TXD signal, the scanner transmits one character and waits. When the CTS signal is turned ON while transmitting a character, the character will be transmitted.

Figure 14: Signal timing

Note: When using loopback (wire connection) for RTS, CTS line of the scanner in this setting, No handshake is not enabled.

c)MODEM

The scanner turns CTS line ON before transmitting data. Other processes are the same as BUSY/READY.

Figure 15: Modem transmit data

Image 22

Contents OPR Document History Limited Warranty and DisclaimersWarranty Copyright 2007 Opticon. All rights reservedContents Cable and Connector Table of Figures Serial number diagram Abstract OverviewPhysical Features Environmental SpecificationsAmbient Light Immunity ConditionsRS-232C Electrical SpecificationsParameter Symbol Min Typ Max Unit USB, WedgeParameter Specification Optical SpecificationsLaser Scanning Specifications Laser Scanning Standard Laser Scanning TiltTechnical Specifications Print Contrast Signal PCSQuiet Zone Scan Area and ResolutionResolution Symbology Digits Depth of Field mmPitch, Skew, and Tilt Pitch Angle PitchSkew Angle and Dead Zone Skew angle and dead zoneTilt Angle Pitch, Skew Angle, Dead ZoneCurvature CurvatureSignal Level Interface SpecificationsRS-232C Interface Settings and Communication U2 settingPin Assignment Signal PinInterface Circuit Communication Format Handshaking Menu/CommandCharacter Format HandshakingFlow Control Time Out Menu/Command BUSY/READYCTS, TXD signal timing ModemACK/NAK Timeout Menu/Command ACK/NAKACK/NAK no Response ACK/NAK-No responseUSB a connector USB Interface Specifications SettingsConnectors USB-HIDDOS/V Wedge Interface Specification Settings Desktop PC When using external keyboardDOS/V Keyboard Connector DOS/V Host ConnectorContact Number Signal Name RS-232C Cable Cable and ConnectorUSB Cable Pin No RS-232C Connector Specification Scanner SideWedge Cable WedgeUSB-HID Default Default SettingsRS-232C Default Wedge Default with external keyboardSymbology Read Transmit Default Settings 1 Readable CodesWedge Default without external keyboard Set Others CodeSymbology Read Transmit Calculate Set Others Code Default Settings 2 Read Options, Trigger, Buzzer Default SettingCollective Packaging Specification Packaging SpecificationsIndividual Packaging Specification Serial NumberShock Drop Test without packaging DurabilityElectrical Noise Drop Test with individual packagingDust and Drip Proof Vibration StrengthStatic Electricity Cable Strength Cable Pulling TestReliability Auto Trigger OptionAuto Trigger Settings Stand Only Trigger optionsAlways ManuallyRegulatory Compliance Laser SafetyProduct Safety EMCShock SafetyTemperature Conditions Foreign MaterialsMechanical Drawing Mechanical drawing