Lathem 7500E manual Setting Monthly Period in Payroll Mode, Set the Mode, Set the Starting date

Page 18

Setting Monthly Period in Payroll Mode

-----Example: Monthly period in Payroll Mode	the starting date is the 21st.

MODE

FUNCTION CHANGE

1 Push the FUNCTION button for 5 seconds and make sure the " " is positioned under the “MODE” mark.

SET

Monthly period

MODE

FUNCTION CHANGE SET

Starting date

MODE

FUNCTION CHANGE SET

Set the "Mode".

2 In the case of monthly period, push the CHANGE button to set the left- side number at "1" and then push the SET button. At that moment, the flashing of the display will change to the right-side number.

Set the "Starting date".

3 To set pay period, you have to input a starting date. In this case, you have to set 21st. Push the CHANGE button to set at "21" and then push the SET button.

4 Push the SET button once again.

You have completed this setting. Go to the next setting listing in

"Default Settings" on page 7 to continue with the setup.

15

14

Image 18

Contents Page Time CORP. with all rights reserved Table of Contents Accessories FeaturesIntroduction Quick Setup Installing Ribbon CassetteCorrect Wrong Setting the Display Hours Set the Display HoursSetting the Time Zone for Atomic Clock Function Default Settings Advanced Settings Contents Mounting Unit on Wall Environmental ConditionsTemplate for wall mounting Leave about 1/8 gap between wall and screw head Level LineAdvanced Settings Setting the TimeSetting the Date Setting the Mode Payroll ModeSetting Weekly Period in Payroll Mode Set the Starting day of the weekSetting Monthly Period in Payroll Mode Set the ModeSet the Starting date Setting Bi-Weekly Period in Payroll Mode Setting Semi-Monthly Period in Payroll Mode Set the 1st starting dateSet the 2nd starting date Job Cost Mode Set the card ResetSetting the Print Format Set the Date/D.O.W. print formatSet the Hour print format Set the Minute print format for totals onlySetting the Rounding Special Note Regarding Punch RoundingSet the Types of rounding Set the Rounding unitSetting the Auto Break Deduction TotalSet the Elapsed time Setting the Max Set the Max In OverrideSet the Max In Value Required Setting the Button Function In/OutDisabled OptionalRequired Setting the Daylight Savings Time Automatic DST correctionYear Month Date Mark means Starting date setting Set the ending date Deleting the Daylight Savings Time settings Setting the Print Language Operations & Functions Radio Signal Reception Resetting Settings Resetting Cards In Job Cost Mode Card reassign All cards reset Card reset Print Example Installing Battery Optional Troubleshooting Error No. Causes and ActionsTroubleshooting Questions & Answers QuestionsDaily Care Specifications Limited One-Year Warranty Form No. OM75E0909 Q0280-61200