Lathem 7500E manual Mounting Unit on Wall, Environmental Conditions

Page 12

INSTALLING THE UNIT

Note: The unit has an internal battery that will save the settings when unplugged.

The unit can be used on a table-top or mounted on a wall. When choosing a location, please note locations to avoid in "Environmental Conditions" at the bottom of the page. If you are using the unit as a table-top, find an appropriate place and skip to Step 3. If using as a wall-mount, take the following steps.

Mounting Unit on Wall

The unit can be mounted on a wall using the supplied mounting fittings.

1 Install wall mount screws (supplied) into a wall 3 15/16" (10 cm) apart.

Be sure to keep about 1/8" ( 3mm) of the screw head out of the wall.

(10cm) 315/16"

Use template on bottom of page 10 if you prefer.

The supplied screws are intended for use on a thick wooden wall or wooden column. Do not use them on any other materials. There is a danger that the unit may come off if used on other materials.

2 Mount the wall mount fittings as shown on the right.

3 Plug the unit into power, and the unit is ready to use.

(3mm)1/8"

Environmental Conditions

Avoid placing the unit in environments that are:

•humid or dusty

•exposed to direct sunshine

•subject to frequent or continuous vibrations

•outside the temperature range between 23˚F (-5˚C) and 113˚F (45˚C)

•affected by chemicals or ozone

9

Image 12

Contents Page Time CORP. with all rights reserved Table of Contents Accessories FeaturesIntroduction Quick Setup Installing Ribbon CassetteCorrect Wrong Setting the Display Hours Set the Display HoursSetting the Time Zone for Atomic Clock Function Default Settings Advanced Settings Contents Mounting Unit on Wall Environmental ConditionsTemplate for wall mounting Leave about 1/8 gap between wall and screw head Level LineAdvanced Settings Setting the TimeSetting the Date Setting the Mode Payroll ModeSetting Weekly Period in Payroll Mode Set the Starting day of the weekSetting Monthly Period in Payroll Mode Set the ModeSet the Starting date Setting Bi-Weekly Period in Payroll Mode Setting Semi-Monthly Period in Payroll Mode Set the 1st starting dateSet the 2nd starting date Job Cost Mode Set the card ResetSetting the Print Format Set the Date/D.O.W. print formatSet the Hour print format Set the Minute print format for totals onlySetting the Rounding Special Note Regarding Punch RoundingSet the Types of rounding Set the Rounding unitSetting the Auto Break Deduction TotalSet the Elapsed time Setting the Max Set the Max In OverrideSet the Max In Value Setting the Button Function In/Out DisabledRequired OptionalRequired Setting the Daylight Savings Time Automatic DST correctionYear Month Date Mark means Starting date setting Set the ending date Deleting the Daylight Savings Time settings Setting the Print Language Operations & Functions Radio Signal Reception Resetting Settings Resetting Cards In Job Cost Mode Card reassign All cards reset Card reset Print Example Installing Battery Optional Troubleshooting Error No. Causes and ActionsTroubleshooting Questions & Answers QuestionsDaily Care Specifications Limited One-Year Warranty Form No. OM75E0909 Q0280-61200