Lathem 7500E manual Quick Setup, Installing Ribbon Cassette

Page 6

2. QUICK SETUP

This setup should take approximately ten to fifteen minutes to completeif you use the default settings. For this setup, take the clock to a comfortable position that has access to power.

Installing Ribbon Cassette

MAKE SURE THE POWER IS ON BEFORE INSTALLING.

1 Hold the left and right sides of the cover and lift up. Then, lift up the antenna case.

2 Turn the knob of the new ribbon cassette in the same direction as the arrow to tighten the ribbon.

3 Place the ribbon cassette inside the time recorder as shown in the figure. Push the ribbon cassette until it snaps into the clasps on both sides. If it is difficult to insert the ribbon cassette, try it while turning the knob.

3

Antenna Case

Knob

Clasp

Knob

Clasp

(located on both sides)

Image 6

Contents Page Time CORP. with all rights reserved Table of Contents Accessories FeaturesIntroduction Quick Setup Installing Ribbon CassetteCorrect Wrong Setting the Display Hours Set the Display HoursSetting the Time Zone for Atomic Clock Function Default Settings Advanced Settings Contents Mounting Unit on Wall Environmental ConditionsTemplate for wall mounting Leave about 1/8 gap between wall and screw head Level LineAdvanced Settings Setting the TimeSetting the Date Setting the Mode Payroll ModeSetting Weekly Period in Payroll Mode Set the Starting day of the weekSetting Monthly Period in Payroll Mode Set the ModeSet the Starting date Setting Bi-Weekly Period in Payroll Mode Setting Semi-Monthly Period in Payroll Mode Set the 1st starting dateSet the 2nd starting date Job Cost Mode Set the card ResetSetting the Print Format Set the Date/D.O.W. print formatSet the Hour print format Set the Minute print format for totals onlySetting the Rounding Special Note Regarding Punch RoundingSet the Types of rounding Set the Rounding unitSetting the Auto Break Deduction TotalSet the Elapsed time Setting the Max Set the Max In OverrideSet the Max In Value Required Setting the Button Function In/OutDisabled OptionalRequired Setting the Daylight Savings Time Automatic DST correctionYear Month Date Mark means Starting date setting Set the ending date Deleting the Daylight Savings Time settings Setting the Print Language Operations & Functions Radio Signal Reception Resetting Settings Resetting Cards In Job Cost Mode Card reassign All cards reset Card reset Print Example Installing Battery Optional Troubleshooting Error No. Causes and ActionsTroubleshooting Questions & Answers QuestionsDaily Care Specifications Limited One-Year Warranty Form No. OM75E0909 Q0280-61200