Lathem 7500E manual Installing Battery Optional

Page 44

6. INSTALLING BATTERY (Optional)

Follow the steps below to install a battery (optional) so that the clock would be operational during a power failure.

Lid

Clasp

Battery

Connector

1 Remove the lid of the battery compartment on the back of the unit by pushing up the center of the lid, and then release it from the two clasps.

2 Position the battery as shown in the figure on the left .

*The connector cord should be on the right side, as shown in the figure.

Connector

Battery	3 Connect the connector. Tuck away the
	3 Connect the connector. Tuck away the
	connector cord into the open space in
	the compartment.

4 Insert the lid into the slot as shown on the left. Keep pressing it down until it hooks to the clasp.

* Make sure the cord is not caught when closing the lid.

41

40

Image 44

Contents Page Time CORP. with all rights reserved Table of Contents Accessories FeaturesIntroduction Quick Setup Installing Ribbon CassetteCorrect Wrong Setting the Display Hours Set the Display HoursSetting the Time Zone for Atomic Clock Function Default Settings Advanced Settings Contents Mounting Unit on Wall Environmental ConditionsTemplate for wall mounting Leave about 1/8 gap between wall and screw head Level LineAdvanced Settings Setting the TimeSetting the Date Setting the Mode Payroll ModeSetting Weekly Period in Payroll Mode Set the Starting day of the weekSet the Starting date Setting Monthly Period in Payroll ModeSet the Mode Setting Bi-Weekly Period in Payroll Mode Set the 2nd starting date Setting Semi-Monthly Period in Payroll ModeSet the 1st starting date Job Cost Mode Set the card ResetSetting the Print Format Set the Date/D.O.W. print formatSet the Hour print format Set the Minute print format for totals onlySetting the Rounding Special Note Regarding Punch RoundingSet the Types of rounding Set the Rounding unitSetting the Auto Break Deduction TotalSet the Elapsed time Set the Max In Value Setting the MaxSet the Max In Override Setting the Button Function In/Out DisabledRequired OptionalRequired Setting the Daylight Savings Time Automatic DST correctionYear Month Date Mark means Starting date setting Set the ending date Deleting the Daylight Savings Time settings Setting the Print Language Operations & Functions Radio Signal Reception Resetting Settings Resetting Cards In Job Cost Mode Card reassign All cards reset Card reset Print Example Installing Battery Optional Troubleshooting Error No. Causes and ActionsTroubleshooting Questions & Answers QuestionsDaily Care Specifications Limited One-Year Warranty Form No. OM75E0909 Q0280-61200