Trango Broadband M900S user manual Command Radio Description Access

Command		Radio	Description		Access
			(power leveling)
pppoeonly		SU	Display current PPPoE filter setting		ro/rw
pppoeonly <on off>		SU	Change PPPoE filter setting		rw
			With PPPoE filter set to ON, only PPPoE packets will pass Default:
			off – Pass All Packets
reboot		AP/SU	Reboot unit		ro/rw
remarks		AP/SU	Display remarks		ro/rw
remarks <str,31 octs>		AP/SU	Overwrite remarks		rw
reset		AP/SU	Reset radio’s system settings back to factory defaults, then reboot		rw
rfrxth		AP/SU	Display current RF RX Threshold		ro/rw
rfrxth <-98..-55>		AP/SU	Change current RF RX Threshold		rw
			default = -98 dBm
rssi		AP/SU	Display current RX RSSI		ro/rw
			Opmode “OFF” only on AP
save <mainimage fpgaimage> <current		AP/SU	Save new firmware. This command gets new firmware image from		rw
chscksum> <new checksum>			TFTP buffer, verifies checksum and writes to flash memory at main
			or FPGA image section.
save sudb		AP	Save SUDB into flash memory		rw
save <systemsetting ss>		AP/SU	Save current configuration into flash memory		rw
set apid <ap-id>		AP	Set AP ID, <ap-id> = 1..255		rw
set baseid <base-id, 4 oct>		AP/SU	Set base station id Base ID = XXXX where X = any alphanumeric		rw
			character except “/”
set defaultopmode <on off>		AP/SU	Set default Opmode to “ON” or “OFF”		rw
			Factory set default Opmode is “OFF”
set httpport [<port #>]		AP/SU	Set or display HTTPD port number		rw
			port # = 1..65534
			default port = 80
set snmpcomm <read write trap id# trap all>		AP/SU	Set SNMP read or write or trap community string		rw
set telnetport [<port #>]		AP/SU	Specify telnet port, <port #> = 1..65534		rw
			Default port = 23
snmpsample <min, 1..60>		AP/SU	Set SNMP sample period		rw
su password <suid all> <rw ro> <new		AP	Change read/write or read-only password of all or a specific		rw
password> <new password>			subscriber
su <all suid>		AP	Display all or specific SU information in SUBD		ro/rw
su info <suid>		AP	Command issued from the AP to gather information about specific		ro/rw
			SUs.
			1.	Distance
			2.	RSSI at AP
			3.	RSSI at SU
			4.	IP address
			5.	Subnet address
			6.	Gateway address
			7.	Device ID
			8.	Hardware version
			9.	FPGA version
			10.	FPGA checksum
			11.	Firmware version
			12.	Firmware checksum
			13.	Firmware datecode
			14. Broadcast/multicast packet filter on/off
			15. Auto scan AP on/off
			16. TCP/IP for AP on/off
			17.	HTTPD on/off
			18. TCP/IP service for Ethernet port on/off
			19. Default channel and antenna
			20. Active channel and antenna
	Trango Broadband Wireless — User Manual M900S Rev. C				Page 44