Trango Broadband M900S user manual RF Link Loopback Test, Link Control

Page 20

Basic Configuration via Browser Interface

Link Control Page

The radio’s firmware includes several useful tools to assist in determining which SUs are associated and the quality of each link. One method for verifying link quality is by using the Link Control page.

On this page the user can immediately see which SUs have associated. In the page shown, SU ID# 1 is associated, and SU ID 17 is not. Consider "Power Off" status synonymous with "not associated."

RF Link

Loopback Test

The RF Link Loopback test is one of the built-in tools for evaluating the quality of the wireless link. Specify an SU ID and time in minutes to conduct the test. The test is prioritized, so it will take precedence over all other traffic. 1600 byte packets are sent and received between the SU and AP at 50 millisecond intervals over the time specified.

Trango Broadband Wireless — User Manual M900S Rev. C

Page 16

Image 20

Contents M900S MHz Wireless Broadband System Table of Contents Table of Figures Warranty Information Firmware Notifications PrefaceFCC Information CanadaIntroduction OverviewAuto-retransmit Feature ARQ SmartPolling & Bandwidth ThrottlingHardware Overview M900S AP and SU Hardware ComponentsConnections and Power Getting StartedRadio Management Concepts CAT-5Switch Settings Browser InterfaceBrowser Interface Login Web Browser System InformationCommand Line Interface Telnet ip address of radioTroubleshooting This section you will Basic Configuration via Browser InterfaceConfiguring the AP’s Subscriber Unit Database Sudb Creating an SU in the SU Database Configure Other Basic AP Parameters Default OpmodeIP Address, Subnet Mask, Gateway Active Channel/PolarizationBasic Configuration via Browser Interface Configure Basic SU Parameters SU Basic SetupLED Summary LED SummaryRF Link Loopback Test Link ControlAdvanced Setup SU Ranging TestOther Key Parameters Site Survey Basic Configuration via CLI Access Point Basic SettingsAP Parameter Description Related CLI Command Set baseid baseidSet defaultopmode on or off Set defaultopmode on time secIpconfig new ip new subnet mask new Set apid apid 00-FF in HEXPower set minmaxdBm Sw 0 onoff default is onOn/off command Sw 3 onoff default is offSubscriber Unit Database Sudb Settings Sw 7 onoff default is onRemarks remarks Sudb add suid prreg device id suid SU IDSubscriber Unit Basic Settings Basic Configuration via CLI SU Parameter Description Related CLI Command Set defaultopmode on or offIpconfig new ip new subnet mask new Set baseid baseidAntenna h v e Sw 0 onoffSw 1 onoff Sw 2 onoffM900S Mounting Hardware Assembly Mounting HardwareAlternative Mounting Cabling and Grounding Considerations Standard Mounting Alternative MountingInstallation Notes Site Selection Command survey time antennaDeployment AP Search and SU Antenna Alignment Example\AP Search Rssi Command for Antenna AlignmentSU Alignment Using LEDs Link Management Commands Collocation and Channel PlanningSu ping su# Su su #Su linktest su# Su testrflink su#ARQ with Selected Repeat and Multirate Feature Radio Management Access Via TCP/IP Su password suid all rw ro new password new passwordManagement SU Management from APLoading Multiple SUs into the Sudb using Dload Command SnmpAP Bandwidth Monitoring Objects for Monitoring and ControlSU Bandwidth Monitoring Snmp Setup Appendix a Command Set Reference Command Radio DescriptionCommand Radio Description Access Su ipconfig suid new IP new Command Radio Description Access Appendix B Specifications Radio Transmit SpecificationsReceiver Specifications Ethernet I/O Specifications Data Input/OutputPower Specifications Mechanical and Environmental Specifications GeneralConnectors/Indicators Standard External Power SupplyIntegrated Antenna M900S-SU and M900S-SU-EXT