Uniden UBC780XLT Restoring a Locked-out Channel, Restoring All Locked-out Channels, Priority Scan

3. The scanner immediately resumes scanning because the locked out channel is no longer in the scanning sequence.

Lockout Tips	• Write down your locked-out channels and put in a convenient place in
	case you need to restore them.

Restoring a Locked-out Channel

1.Press MAN.

2.Select a locked out channel.

a.Enter the channel number.

b.Then press MAN again.

3.Press L/O to unlock the channel. The L/ O icon goes out.

Restoring All Locked-out Channels

You can restore all locked-out channels in a bank only when a bank is selected for scan. If you have deselected a bank and you want to restore all of its locked-out channels using the steps below, you must press SCAN and then press the number of the bank on your keypad.

1. Press MAN.

Note: You must be in Manual mode before restoring all locked-out channels.

2.Press and hold L/O for about two seconds.

You will hear two beeps when all the channels have been restored.

MUTE

Priority Scan

When Priority Scan is turned on, your scanner checks the priority channel every two seconds for activity. If a signal is present on the priority channel, your scanner monitors the channel until the transmission ends, then resumes normal scanning. You can designate one channel in each bank as a Priority Channel. By default, the first channel in each bank is the priority channel, but you can change this.

To activate Priority Scan (in either the Manual or Scan Mode):

1. Press PRI.

Note: If you have locked out the priority channel,

ERROR message appears when you select

Priority mode.

2. Press PRI again at anytime to deactivate Priority Scan.

24