Uniden SC200 manual Using Ctcss Tone or Cdcss Tone Search While Searching

5.Repeat Steps 1 - 4 to search for tones associated with other stored frequencies.

If you want to program tones for several stored frequencies, follow these steps:

￿After you program a CTCSS tone or CDCSS tone with a stored frequency, the CTCSS Tone or CDCSS tone Search Mode is canceled. The CTCSS or CDCSS indicator remains on but does not flash. To activate the CTCSS Tone

Search Mode or CDCSS Tone Search Mode

again, press and hold until you hear two short beeps.

If you decide to cancel the CTCSS Tone Search

Mode or CDCSS Tone Search Mode while

scanning, press and hold until you hear two short beeps and the CTCSS or CDCSS indicator turns off.

￿You can select the CTCSS Search Mode or

CDCSS Tone Search Mode before pressing

in Manual Mode. Simply, press and hold

until the CTCSS or DCS indicator begins

flashing, and then press .

When your scanner stops, the CTCSS Tone or CDCSS Tone search begins immediately. If a

tone is found before the transmission ends,

pressto program the tone with the frequency stored in the channel.

Using CTCSS Tone or CDCSS Tone Search While Searching

1.Set a Search Range.

For information about setting a search range, see Limit Search on page 27.

2.Press and hold until you hear two short beeps.

33