Uniden SC200 manual Setup, Installing the Battery Pack

Page 17

Setup

The SportCat comes with a rechargeable Nickel-Cadmium Battery Pack. When fully charged, this Battery Pack will supply up to 12 hours of dependable use. (With the Squelch control in “closed” position.)

Before using the SportCat for the first time, or whenever the LOW BATTERY Indicator appears on the LCD display, you should fully charge the Battery Pack.

Note: When the Battery Pack is low, the Low Battery Indicator will start to blink. After about 10 minutes, the scanner will shut itself off to prevent the battery from becoming completely discharged.

Before charging, you must first install the Battery Pack according to the steps below.

Installing the Battery Pack

1. Open the cover.

2. Insert the battery pack.

3.Replace cover and press

down until it clicks into place.

15

Image 17

Contents SC200 Do not short circuit the battery PrecautionsContents CTCSS/CDCSS Tone Frequencies Hz About Your New SportCat What is Scanning?What is Searching? What is Ctcss and CDCSS? Range Step Band Subject Types of CommunicationUnpacking Where to Obtain More InformationFeature Highlights Page Top View Controls and IndicatorsFront View Indicates Weather Scan Mode Page Bands. Then press /BAND again to start band search Page Installing the Battery Pack SetupMounting the Flexible Antenna Installing the Belt ClipUsing the Earphone Operation Overview Readjust the volume to a comfortable listening levelPage Programming By Manual Entry Programming ChannelsAppear on the display. If you want to store the frequency Deleting a Stored FrequencyProgramming with Search Programming Channels with Alpha Characters Alert Beep Setting Bank Scanning ScanningPriority Scan DelayLooking for Locked Out Channels Locking Out ChannelsBand Weather Channel ScanningBand Search SearchingLimit Search Press Enter the lower limit of your search rangeSearch Skip Frequency VFO SearchProgramming a Ctcss Tone/CDCSS Tone CTCSS/CDCSS OperationSearching for Ctcss Tones/CDCSS Tones Using Tone Search Change per 1sec Using Ctcss Tone or Cdcss Tone Search While Searching Ctcss and DCS begins flashing in display Changing a CTCSS/CDCSS Tone Press to change the Ctcss tone Erasing a CTCSS/CDCSS TonePage Remote Interface Connecting the ScannerScanner to Scanner SmartScan ModeScanner to External Modem Page Page Menu for SmartScan Flow control setting Xon/Xoff, RTS/CTS, Off Dial typeProgram Lock Whenever you press Transfer speedPress . The phone number appears Press to place the call Transfer SpeedFlow Control Smartscanner Tips Dial TypePress . Clone Mode Clone ModeOn the scanner that is the Slave Unit, press Key until Replacing the Battery Pack Care and MaintenanceRepairs CleaningLocation Proper Care of Your Scanner BirdiesTechnical Specifications Size 2-1/2 W x 1-3/4 D x 11-3/4 H With antenna attached Ctcss CTCSS/CDCSS Tone Frequencies HzOptional Accessories Replacement Parts Problem Solution TroubleshootingProblem Solution One Year Limited Warranty Page Covered Under ONE or More of the Following U.S. Patents